In this study, bioactive composite systems based on natural polymers (chitosan and lignin) were prepared in this study. The structural, mechanical, and morphological properties of chitosan-based materials containing various amounts of lignin filler were investigated. The infra-red IR spectroscopy data confirmed the formation of chemical bonds between the components of the obtained composites. The mechanical properties of film samples were studied in air and in physiological solution. It was demonstrated that the breaking elongation values of the obtained film samples in the wet state were higher (150–160%) than the corresponding (average) value of a pure chitosan film (100%). The scanning electron microscopy and atomic force microscopy data demonstrated that the introduction of lignin had caused significant changes in the surface morphology of films. The appearance of a strongly pronounced texture and porosity facilitated cell proliferation on the surface of composites, i.e., the bioactivity of film samples was enhanced with an increasing lignin content in the chitosan matrix.

The deformation behavior of blends consisting of a styrene–butadiene star block copolymer and a polystyrene homopolymer was studied by high‐voltage electron microscopy with a tensile device. The mechanical properties and micromechanical deformation mechanisms in the star block copolymer/polystyrene blends were directly influenced by their morphology. Although the pure block copolymer deformed in a very unequal manner (because of a thin‐layer‐yielding mechanism) and revealed no local deformation zones, a transition to the formation of crazelike zones was observed in the blends. This transition in the deformation mechanisms was correlated to the abrupt change in the macroscopic strain at break of the injection‐molded specimens. At lower contents of added polystyrene, a craze‐stopping mechanism was observed, whereas the blends with higher polystyrene contents demonstrated crazing like that in pure polystyrene. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1157–1167, 2003

Abstract:The modification of bioresorbable polyester surfaces in order to alter their biointeractions presents an important problem in biomedical polymer science. In this study, the covalent modification of the surface of poly(lactic acid)-based (PLA-based) films with poly(acryl amide) and sodium alginate hydrogels was performed to change the non-specific polyester interaction with proteins and cells, as well as to make possible the covalent attachment of low-molecular weight ligands and to control protein release. The effect of such modification on the film surface properties was studied. Parameters such as swelling, water contact angle, surface area, and binding capacity of low-molecular weight substances were evaluated and compared. The comparative study of adsorption of model protein (BSA) on the surface of non-modified and modified films was investigated and the protein release was evaluated. Cell viability on the surface of hydrogel-coated films was also tested. The developed approach could be applied for the modification of PLA-based scaffolds for tissue engineering and will be further studied for molecular-imprinting of biomolecules on the surface of polyester-based materials for control of biointeractions.

No abstract