No abstract

Abstract. Injection of fluids into deep saline aquifers causes a pore pressure increase in the storage formation, and thus displacement of resident brine. Via hydraulically conductive faults, brine may migrate upwards into shallower aquifers and lead to unwanted salinisation of potable groundwater resources. In the present study, we investigated different scenarios for a potential storage site in the Northeast German Basin using a three-dimensional (3-D) regional-scale model that includes four major fault zones. The focus was on assessing the impact of fault length and the effect of a secondary reservoir above the storage formation, as well as model boundary conditions and initial salinity distribution on the potential salinisation of shallow groundwater resources. We employed numerical simulations of brine injection as a representative fluid.Our simulation results demonstrate that the lateral model boundary settings and the effective fault damage zone volume have the greatest influence on pressure build-up and development within the reservoir, and thus intensity and duration of fluid flow through the faults. Higher vertical pressure gradients for short fault segments or a small effective fault damage zone volume result in the highest salinisation potential due to a larger vertical fault height affected by fluid displacement. Consequently, it has a strong impact on the degree of shallow aquifer salinisation, whether a gradient in salinity exists or the saltwater-freshwater interface lies below the fluid displacement depth in the faults. A small effective fault damage zone volume or low fault permeability further extend the duration of fluid flow, which can persist for several tens to hundreds of years, if the reservoir is laterally confined. Laterally open reservoir boundaries, large effective fault damage zone volumes and intermediate reservoirs significantly reduce vertical brine migration and the potential of freshwater salinisation because the origin depth of displaced brine is located only a few decametres below the shallow aquifer in maximum.The present study demonstrates that the existence of hydraulically conductive faults is not necessarily an exclusion criterion for potential injection sites, because salinisation of shallower aquifers strongly depends on initial salinity distribution, location of hydraulically conductive faults and their effective damage zone volumes as well as geological boundary conditions.

To assess the long-term reservoir stabilisation at the Ketzin pilot site (Germany), the contribution of the four CO 2 trapping mechanisms (structural, residual, dissolution and mineralisation trapping) was determined by numerical modelling. In the first step, dynamic flow simulations were undertaken using a reservoir simulator. The second step comprised batch simulations applying a geochemical simulator. Coupling between both simulators was achieved by time-step dependent integration of water saturation calculated in the reservoir simulations. After a simulation time of 16,000 years, about 98.3 % of the injected CO 2 is dissolved in the formation fluid and 1.5 % mineralised, while residual trapping contributes with 0.2 % and structural trapping is negligible.

Pore pressure variation resulting from geological CO2 storage may compromise reservoir, caprock and fault integrity. Therefore, we investigate the mechanical impact of industrial-scale CO2 storage at a prospective Danish site by coupled 3D hydro-mechanical simulations carried out by two independent modelling groups. Even though the two chosen modelling strategies are not identical, simulation results demonstrate that storage integrity is maintained at any time. Vertical displacements are mainly determined by hydraulic fault conductivity influencing spatial pore pressure elevation. The introduced fault zone implementation in the hydromechanical model allows for localization of potential leakage pathways for formation fluids along the fault plane.

No abstract