No abstract

No abstract

Background. This in vitro study aimed to compare the antibacterial effect of different concentrations of sodium hypochlorite on elimination of Enterococcus faecalis from root canal systems of primary teeth with or without a passive sonic irrigation system (EndoActivator). Methods. The root canals of 120 extracted single-rooted primary incisors were prepared using the crown-down technique. The teeth were autoclaved and inoculated with E. faecalis. The infected samples were then randomly divided into 6 experimental groups of 15 and positive and negative control groups as follows: group 1: 0.5% sodium hypochlorite solution; group 2: 2.5% sodium hypochlorite solution; group 3: 5% sodium hypochlorite solution; group 4: 0.5% sodium hypochlorite solution + sonic activation; group 5: 2.5% sodium hypochlorite solution + sonic activation; and group 6: 5% sodium hypochlorite solution + sonic activation. Microbiological samples were collected before and after disinfection procedures and the colony-forming units were counted. Statistical analyses were performed using the two-way ANOVA and post hoc Duncan's tests in cases of significant difference. Results. There were no significant differences between the groups in any of the variables (concentration of antiseptic or use of sonic irrigation system). Conclusion. Use of passive sonic irrigation systems in endodontic treatment of single-rooted primary teeth is of no benefit compared to regular needle irrigation. The results of this study also recommends use of lower concentrations of sodium hypochlorite solution (0.5%) for irrigation of the root canal system rather than higher concentrations given approximately equal efficacy.

No abstract

Objectives:This in vitro study evaluated the microtensile bond strength (MTBS) of a methacrylate-based compared to a silorane-based resin composite in Class I cavity using different placement techniques.Materials and Methods:Class I cavities with dimension of (4 mm long, 4 mm wide, 3 mm deep) were prepared in extracted sound human molars. The teeth were randomly divided into six groups. The first three groups were filled with Filtek P90 using three methods of insertion; bulk, incremental and snow-plow, and the remaining three groups were filled with Clearfil AP-X using the same three placement techniques. After 24 hours of storage in water at 37°C, the specimens were thermocycled to 1000 cycles. Specimens were prepared for MTBS testing by creating bonded beams obtained from the pulpal floor. Statistical analysis used: Statistical analyses of data were performed by two-way ANOVA/Tukey (α=.05).Results:The experiment showed significant differences between the two resin composites with regard to filling techniques (P<0.05). The MTBS was significantly higher in each of Filtek P90 subgroup compared to Clearfil AP-X ones (P<0.05). With respect to filling technique in both resin composites, bulk insertion showed the significantly lowest MTBS (P<0.05), while no significant difference was found between the outcome of incremental and snow-plow techniques (P>0.05).Conclusion:Silorane-based resin composite as opposed to methacrylate based resin composite and layering placements in contrast to bulk filling method had higher microtensile bond strength.