In today’s world, distributed generation (DG) is an outstanding solution to tackle the challenges in power grids such as the power loss of the system that is intensified by the exponential increase in demand for electricity. Numerous optimization algorithms have been used by several researchers to establish the optimal placement and sizing of DGs to alleviate this power loss of the system. However, in terms of the reduction of active power loss, the performance of these algorithms is weaker. Furthermore, the premature convergence, the precision of the output, and the complexity are a few major drawbacks of these optimization techniques. Thus, this paper proposes the multileader particle swarm optimization (MLPSO) for the determination of the optimal locations and sizes of DGs with the objective of active power loss minimization while surmounting the drawbacks in previous algorithms. A comprehensive performance analysis is carried out utilizing the suggested approach on the standard IEEE 33 bus system and a real radial bus system in the Malaysian context. The findings reveal a 67.40% and an 80.32% reduction of losses in the two systems by integrating three DGs with a unity power factor, respectively. The comparison of the results with other optimization techniques demonstrated the effectiveness of the proposed MLPSO algorithm in optimal placement and sizing of DGs.

A competent methodology based on the active power loss reduction for optimal placement and sizing of distributed generators (DGs) in an active distribution network (ADN) with several soft open points (SOPs) is proposed. A series of SOP combinations are explored to generate different network structures and they are utilized in the optimization framework to identify the possible solutions with minimum power loss under normal network conditions. Furthermore, a generalized methodology to optimize the size and the location of a predefined number of DGs with a predefined number of SOPs is presented. A case study on the modified IEEE 33 bus system with three DGs and five SOPs was conducted and hence the overall network power loss and the voltage improvement were examined. The findings reveal that the system loss of the passive network without SOPs and DGs is reduced by 79.5% using three DGs and five SOPs. In addition, this research work introduces a framework using the DG size and the impedance to the DG integration node, to propose a region where the DGs can be optimally integrated into an ADN that includes several SOPs.

The modern photovoltaic (PV) inverters are embedded with smart control capabilities such as Volt/Var and Volt/Watt functions to mitigate overvoltage issues. The Volt/Var control has gained a significant attention in regulating grid voltage through reactive power compensation. However, the reactive power capability of a PV inverter is limited during peak irradiance and could be improved by curtailing the active power generation and by oversizing the PV inverter. This paper analyzes the performance of Volt/Var function of smart PV inverters in mitigating overvoltage issues due to high PV integration and thus increasing the hosting capacity of low voltage distribution networks (LVDNs). The study is conducted on a real Malaysian LVDN considering two different Volt/Var set points under different PV penetration levels. Results demonstrate that the oversized smart PV inverter could enhance the Volt/Var functionality by increasing its reactive power capability than a typical smart PV inverter. Further it reveals that adaptation of sensitive Volt/Var set points with shorter deadbands increase the PV hosting capacity of LVDNs.

<span>Minimization of real power loss and improvement of voltage authenticity of the network are amongst the key issues confronting power systems owing to the heavy demand development problem, contingency of transmission and distribution lines and the financial costs. The distributed generators (DG) has become one of the strongest mitigating strategies for the network power loss and to optimize voltage reliability over integration of capacitor banks and network reconfiguration. This paper introduces an approach for the optimizing the  placement and sizes of different types of DGs in radial distribution systems using a fine-tuned particle swarm optimization (PSO). The suggested approach is evaluated on IEEE 33, IEEE 69 and a real network in Malaysian Context. Simulation results demonstrate the productiveness of active and reactive power injection into the electric power system and the comparison depicts that the suggested fine-tuned PSO methodology could accomplish a significant reduction in network power loss than the other research works.</span>

Photovoltaic (PV) system installation has encouraged to be further expedited to minimize climate change and thus, rooftop solar PV systems have been sparkled in every corner of the world. However, due to technological constraints linked to voltage and currents, the PV hosting capacity has been substantially constrained. Therefore, this paper proposes a competent approach to maximize PV hosting capacity in a low voltage distribution network based on voltage control and dynamic line rating of the cables. Coordinated voltage control is applied with an on-load tap changing transformer, and reactive power compensation and active power curtailment of PV inverters. A case study with probabilistic and deterministic assessments is carried out on a real Sri Lankan network to show how the PV hosting capacity is constrained. The findings revealed the capability of integrated voltage control schemes and dynamic line rating in maximizing hosting capacity. The study is expanded by incorporating the PV rephasing approach in conjunction with the aforementioned control techniques, and the effectiveness of PV-rephasing is clearly demonstrated. When compared to voltage control and conductor static rating, the combined rephasing, voltage control, and DLR yielded a 60% increase in PV hosting capacity.