Recombinase-mediated cassette exchange (RMCE) is a powerful tool for unidirectional integration of DNA fragments of interest into a pre-determined genome locale. In this report, we examined how the efficiency of dual RMCE catalyzed by Flp and Cre depends on the nature of transcription units that express the recombinases. The following recombinase transcription units were analyzed: (i) Flp and Cre genes expressed as individual transcription units located on different vectors, (ii) Flp and Cre genes expressed as individual transcription units located on the same vector, (iii) Flp and Cre genes expressed from a single promoter and separated by internal ribosome entry sequence and (iv) Flp and Cre coding sequences separated by the 2A peptide and expressed as a single gene. We found that the highest level of dual RMCE (35–45% of the transfected cells) can be achieved when Flp and Cre recombinases are expressed as Flp–2A–Cre and Flp–IRES–Cre transcription units. In contrast, the lowest level of dual RMCE (∼1% of the transfected cells) is achieved when Flp and Cre are expressed as individual transcription units. The analysis shows that it is the relative Flp–to–Cre ratio that critically affects the efficiency of dual RMCE. Our results will be helpful for maximizing the efficiency of dual RMCE aimed to engineer and re-engineer genomes.

Recombinase-mediated cassette exchange, or RMCE, is a clean approach of gene delivery into a desired chromosomal location, as it is able to insert only the required sequences, leaving behind the unwanted ones. RMCE can be mediated by a single site-specific DNA recombinase or by two recombinases with different target specificities (dual RMCE). Recently, using the Flp–Cre recombinase pair, dual RMCE proved to be efficient, provided the relative ratio of the enzymes during the reaction is optimal. In the present report, we analyzed how the efficiency of dual RMCE mediated by the Flp–Int (HK022) pair depends on the variable input of the recombinases—the amount of the recombinase expression vectors added at transfection—and on the order of the addition of these vectors: sequential or simultaneous. We found that both in the sequential and the simultaneous modes, the efficiency of dual RMCE was critically dependent on the absolute and the relative concentrations of the Flp and Int expression vectors. Under optimal conditions, the efficiency of ‘simultaneous’ dual RMCE reached ∼12% of the transfected cells. Our results underline the importance of fine-tuning the reaction conditions for achieving the highest levels of dual RMCE.

Efficient and precise genome manipulations can be achieved by the Flp/FRT system of site-specific DNA recombination. Applications of this system are limited, however, to cases when target sites for Flp recombinase, FRT sites, are pre-introduced into a genome locale of interest. To expand use of the Flp/FRT system in genome engineering, variants of Flp recombinase can be evolved to recognize pre-existing genomic sequences that resemble FRT and thus can serve as recombination sites. To understand the distribution and sequence properties of genomic FRT-like sites, we performed a genome-wide analysis of FRT-like sites in the human genome using the experimentally-derived parameters. Out of 642,151 identified FRT-like sequences, 581,157 sequences were unique and 12,452 sequences had at least one exact duplicate. Duplicated FRT-like sequences are located mostly within LINE1, but also within LTRs of endogenous retroviruses, Alu repeats and other repetitive DNA sequences. The unique FRT-like sequences were classified based on the number of matches to FRT within the first four proximal bases pairs of the Flp binding elements of FRT and the nature of mismatched base pairs in the same region. The data obtained will be useful for the emerging field of genome engineering.

Genome engineering relies on DNA modifying enzymes that are able to locate a DNA sequence of interest and initiate a desired genome rearrangement. Currently, the field predominantly utilizes site-specific DNA nucleases that depend on the host DNA repair machinery to complete a genome modification task. We show here that genome engineering approaches that employ target-specific variants of self-sufficient, versatile site-specific DNA recombinase Flp can be developed into promising alternatives. We demonstrate that the Flp variant evolved to recombine an FRT-like sequence FL-IL10A, which is located upstream of the human interleukin-10 gene, can target this sequence in the model setting of hamster CHO and human HEK293 cells. This target-specific Flp variant is able to perform the integration reaction and, when paired with another recombinase, the dual RMCE reaction. The efficiency of the integration reaction in human cells can be enhanced by ‘humanizing’ the Flp variant gene and by adding the NLS sequence to the recombinase.