No abstract

No abstract

This is an open-access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/3.0/), which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.Objectives: This study was aimed at evaluating the clinical usability of a new caries activity test (Cariview ® ), which was based on the acidogenic potential of plaque by evaluating it's correlation with the DMFT index and comparing the results of Cariview ® with those of previous caries activity tests in an adult group. Methods: Teeth of 74 subjects were examined, and the DMFT index was calculated according to World Health Organization (WHO) criteria to determine the past caries experience. Caries activity tests were performed according to manufacturer's instructions. For Cariview ® test, plaque samples were collected from the tooth surface by using a sterile cotton swab and incubated at 37 o C for 48 h; an indicator was added to observe the color changes according to the plaque acidogenicity. The subjects were classified into three groups (Low, Moderate, High) according to the level of caries risk. The data were assessed using one-way ANOVA to compare the caries experiences of risk groups according to the caries activity test results, and the relationships between the caries activity tests and the DMFT index were evaluated. Results: The overall mean DMFT index was 5.70±4.42. There was a significant difference in the DMFT index among the caries risk groups (Low, Moderate, High) according to the Cariview ® test result (P=0.036). Further, there was a positive correlation between the Cariview ® score and the DMFT index (r=0.23, P=0.047) and between the Cariview ® score and the previous caries activity tests score (P<0.01). Conclusions:The new caries activity test (Cariview ® ) can be easily used at dental clinics and enables precise caries risk assessment.

Electrically conductive CNT reinforced polycarbonate matrix nanocomposites with high strain-to-failure were fabricated by inserting polyvinylalcohol as a surface modifier through a melt blending process. The addition of PVA by coating the CNT through a simple ball milling process before melt blending with a polycarbonate matrix resulted in an increased percolation limit as compared to that prepared using uncoated CNTs, while the electrical conductivity was maintained at a similar level of 2 x 10(-2) S/cm. However, tensile elongation was considerably improved by the addition of PVA and remained at 81% even though 5 wt% of the CNTs were added for electrical conductivity, while elongation dropped to 25% when the CNTs were not coated with PVA. The addition of PVA induces homogeneous dispersion of CNTs during the melt blending process and can enhance both electrical conductivity and mechanical durability.

The aims of this study were to identify the optimal concentration of coated orthodontic elastomerics using a layer-by-layer technique that can release chlorhexidine (CHX) as an antimicrobial material, and to measure the physical properties and antimicrobial effects of the coated elastomerics. Ethyl cellulose (EC) was used as the polymer, and five study groups with various combinations of solvents (i.e., ethanol and dichloromethane [DCM]) were included. The coated elastomerics were evaluated with a spectrophotometer to confirm the release of CHX, and their surfaces were observed by SEM. The CHX+EC+DCM group sustained antimicrobial release for the longest period (168 h, p<0.001) and exhibited the largest antimicrobial effect in an inhibition zone test using S. mutans for 7 days (p<0.05). This group had most effective physical properties and antimicrobial effects of coated elastomerics produced using a layerby-layer technique, and so its composition should be considered for use in clinical applications in orthodontics.