The bit independence criterion was proposed to evaluate the security of the S-boxes used in block ciphers. This paper proposes an algorithm that extends this criterion to evaluate the degree of independence between the bits of inputs and outputs of the stream ciphers. The effectiveness of the algorithm is experimentally confirmed in two scenarios: random outputs independent of the input, in which it does not detect dependence, and in the RC4 ciphers, where it detects significant dependencies related to some known weaknesses. The complexity of the algorithm is estimated based on the number of inputs l, and the dimensions, n and m, of the inputs and outputs, respectively.

Entropy makes it possible to measure the uncertainty about an information source from the distribution of its output symbols. It is known that the maximum Shannon’s entropy of a discrete source of information is reached when its symbols follow a Uniform distribution. In cryptography, these sources have great applications since they allow for the highest security standards to be reached. In this work, the most effective estimator is selected to estimate entropy in short samples of bytes and bits with maximum entropy. For this, 18 estimators were compared. Results concerning the comparisons published in the literature between these estimators are discussed. The most suitable estimator is determined experimentally, based on its bias, the mean square error short samples of bytes and bits.

In the last three decades, the RC4 has been the most cited stream cipher, due to a large amount of research carried out on its operation. In this sense, dissimilar works have been presented on its performance, security, and usability. One of the distinguishing features that stand out the most is the sheer number of RC4 variants proposed. Recently, a weakness has been reported regarding the existence of statistical dependence between the inputs and outputs of the RC4, based on the use of the strict avalanche criterion and the bit independence criterion. This work analyzes the influence of this weakness in some of its variants concerning RC4. The five best-known variants of RC4 were compared experimentally and classified into two groups according to the presence or absence of such a weakness.

In 2005, Philippe Guillot presented a new construction of Boolean functions using linear codes as an extension of the Maiorana–McFarland’s (MM) construction of bent functions. In this paper, we study a new family of Boolean functions with cryptographically strong properties, such as non-linearity, propagation criterion, resiliency, and balance. The construction of cryptographically strong Boolean functions is a daunting task, and there is currently a wide range of algebraic techniques and heuristics for constructing such functions; however, these methods can be complex, computationally difficult to implement, and not always produce a sufficient variety of functions. We present in this paper a construction of Boolean functions using algebraic codes following Guillot’s work.

The analysis of independence between statistical randomness tests has had great attention in the literature recently. Dependency detection between statistical randomness tests allows one to discriminate statistical randomness tests that measure similar characteristics, and thus minimize the amount of statistical randomness tests that need to be used. In this work, a method for detecting statistical dependency by using mutual information is proposed. The main advantage of using mutual information is its ability to detect nonlinear correlations, which cannot be detected by the linear correlation coefficient used in previous work. This method analyzes the correlation between the battery tests of the National Institute of Standards and Technology, used as a standard in the evaluation of randomness. The results of the experiments show the existence of statistical dependencies between the tests that have not been previously detected.