Abstract-The use of amateur drones (ADrs) is expected to significantly increase over the upcoming years. However, regulations do not allow such drones to fly over all areas, in addition to typical altitude limitations. As a result, there is an urgent need for ADrs surveillance solutions. These solutions should include means of accurate detection, classification, and localization of the unwanted drones in a no-fly zone. In this paper, we give an overview of promising techniques for modulation classification and signal strength based localization of ADrs by using surveillance drones (SDrs). By introducing a generic altitude dependent propagation model, we show how detection and localization performance depend on the altitude of SDrs. Particularly, our simulation results show a 25 dB reduction in the minimum detectable power or 10 times coverage enhancement of an SDr by flying at the optimum altitude. Moreover, for a target no-fly zone, the location estimation error of an ADr can be remarkably reduced by optimizing the positions of the SDrs. Finally, we conclude the paper with a general discussion about the future work and possible challenges of the aerial surveillance systems.

The growing use of Unmanned Aerial Vehicles (UAVs) for various applications requires ubiquitous and reliable connectivity for safe control and data exchange between these devices and ground terminals. Depending on the application, UAV-mounted wireless equipment can either be an aerial user equipment (AUE) that co-exists with the terrestrial users, or it can be a part of wireless infrastructure providing a range of services to the ground users. For instance, AUE can be used for real-time search and rescue and/or video streaming (surveillance, broadcasting) and Aerial Base Station (ABS) can enhance coverage, capacity and energy efficiency of wireless networks. In both cases, UAV-based solutions are scalable, mobile, easy and fast to deploy. However, several technical challenges have to be addressed before such solutions will become widely used. In this work, we present a tutorial on wireless communication with UAVs, taking into account a wide range of potential applications. The main goal of this work is to provide a complete overview of the main scenarios (AUE and ABS), channel and performance models, compare them, and discuss open research points. This work is intended to serve as a tutorial for wireless communication with UAVs, which gives a comprehensive overview of the research done until now and depicts a comprehensive picture to foster new ideas and solutions while avoiding duplication of past work. We start by discussing the open challenges of

Investigation of small-scale fading in indoor peerto-peer networks based on radio channel measurements shows that Rayleigh or double-Rayleigh fading with or without lineof-sight (LOS) component can occur, depending on the mobility and on the scattering properties of the environment. While in double-mobile scenarios, the predominant fading mechanism is a combination of Rayleigh and double-Rayleigh fading, Rician fading and fading events caused by combination of a constant term with a Double Rayleigh component are also occasionally observed. In single-mobile scenarios, temporal fading is Rician or Rayleigh distributed. Additionally, measurements reveal that fading statistics evolve significantly over time, even for smallscale motions of the nodes. We model the transitions between the fading states by means of a hidden Markov model, parameterized from our measurements. Eventually, we propose a complete simulation model that generates channel realizations by combining measurement-based first-order statistics with geometry-based second-order statistics for both types of node mobility.

Cellular connectivity for UAV systems is interesting because it promises coverage in beyond visual line of sight scenarios. Inter-cell interference has been shown to be the main limiting factor at high altitudes. Using a realistic 3D simulator model, with real base station locations, this study confirms that UAVs at high altitudes suffer from significant interference, resulting in a worse coverage compared to ground users. When replacing the existing base stations by mmWave cells, our results indicate that ground coverage is decreased to only 90%, while UAVs just above rooftop level have a coverage probability of 100%. However, UAVs at higher altitude still suffer from excessive interference. Beamforming has the potential to improve mmWave link budget and to decrease interference and is for this reason a promising technology for ensuring connectivity to aerial users.

No abstract