Optical fibres constitute an exceptional sensing platform. However, standard fibres present an inherent sensing challenge: they confine light to an inner core. Consequently, distributed fibre sensors are restricted to the measurement of conditions that prevail within the core. This work presents distributed analysis of media outside unmodified, standard fibre. Measurements are based on stimulated scattering by guided acoustic modes, which allow us to listen where we cannot look. The protocol overcomes a major difficulty: guided acoustic waves induce forward scattering, which cannot be mapped using time-of-flight. The solution relies on mapping the Rayleigh backscatter contributions of two optical tones, which are coupled by the acoustic wave. Analysis is demonstrated over 3 km of fibre with 100 m resolution. Measurements distinguish between air, ethanol and water outside the cladding, and between air and water outside polyimide-coated fibres. The results establish a new sensor configuration: optomechanical time-domain reflectometry, with several potential applications.

No abstract

Fiber-optic sensors provide remote access, are readily embedded within structures, and can operate in harsh environments. Nevertheless, fiber-optic sensing of liquids has been largely restricted to measurements of refractive index and absorption spectroscopy. The temporal dynamics of fluid evaporation have potential applications in monitoring the quality of water, identification of fuel dilutions, mobile point-of-care diagnostics, climatography and more. In this work, the fiber-optic monitoring of fluids evaporation is proposed and demonstrated. Sub-nano-liter volumes of a liquid are applied to inline fiber-optic micro-cavities. As the liquid evaporates, light is refracted out of the cavity at the receding index boundary between the fluid and the ambient surroundings. A sharp transient attenuation in the transmission of light through the cavity, by as much as 50 dB and on a sub-second time scale, is observed. Numerical models for the transmission dynamics in terms of ray-tracing and wavefront propagation are provided. Experiments show that the temporal transmission profile can distinguish between different liquids.

No abstract

Distributed Brillouin fiber sensors typically rely on the reconstruction of the steady-state Brillouin gain spectrum (BGS), through spectral scanning of the frequency offset between the pump and signal waves. In this work, we propose and demonstrate an alternative approach, in which the local Brillouin frequency shift (BFS) is extracted from temporal transient analysis of the step response of the amplified signal wave. Measurements are taken at only two arbitrary frequency offsets between pump and signal. No spectral scanning and no prior knowledge of a reference BGS are necessary. The principle is supported by analytic and numeric solutions of the differential equations of stimulated Brillouin scattering. The BFS of a 2 meters-long fiber under test was measured with 1 MHz accuracy and a dynamic range of 200 MHz. Transient measurements were also performed in a Brillouin optical correlation domain analysis (B-OCDA) experiment with 4 cm resolution, standard deviation of 2.4 MHz and 100 MHz dynamic range. A 4 cm-wide hot-spot was properly identified in the measurements. Multiple correlation peaks could be addressed in a single flight of a pump pulse. The results represent the first B-OCDA that is free of spectral scanning. This new measurement concept may be applicable to random-access distributed and dynamic monitoring of sound and vibration.