ZnO-based light emitting diodes were fabricated on c-plane sapphire using ZnO:P∕Zn0.9Mg0.1O∕ZnO∕Zn0.9Mg0.1O∕ZnO:Ga p-i-n heterostructures. The p-i-n heterojunction diodes are rectifying and show light emission under forward bias. The electroluminescence spectra shows deep level emission at low bias, but near band edge ultraviolet emission at high voltage bias. A decrease in leakage currents in as-fabricated structures was achieved via low temperature oxygen annealing.
A thorough structural characterization of the synthesized Ni-, Zn-, and Cd-nitroprussides (NPs) with X-ray diffraction (XRD), thermogravimetric analysis, diffuse reflectance infrared Fourier transform spectrometry (DRIFTS), M€ ossbauer spectroscopy, and magnetic measurements was performed. However, the innovative part of the research was the study of the structural effects and the interactions of the CO 2 molecule with the Ni-, Zn-, Cd-NP frameworks. DRIFTS of adsorbed molecules, high pressure adsorption, and in situ XRD adsorption experiments were performed. The DRIFTS spectra displayed peaks assigned to CO 2 physical adsorption and the formation of adducts (M 2+ 3 3 3 OdCdO). The fitting of the adsorption data to the DubininÀRadushkevich equation and a Langmuir-type equation for volume filling allowed the calculation of the micropore volume and the isosteric heats of adsorption. The calculated parameters indicated an unusual behavior of the adsorption process in Cd-NP at high pressure. This fact was caused by the interaction of CO 2 molecules with the framework cations and the small adsorption space of Cd-NP. The Ni-and Zn-NPs behaved normally. The Pawley fitting of the XRD profiles of the dehydrated materials and under CO 2 adsorption indicated that in both cases Ni-NP, Zn-NP, and Cd-NPs displayed the Fm3m, R3, and Pnma space groups, respectively. The dehydrated samples demonstrated a change in the cell parameters. However, only Cd-NP presented a noticeable variation of its cell parameters under CO 2 adsorption. This fact was linked to the unusual behavior of the adsorption process in Cd-NP. Additionally, was shown that dehydrated Ni-, Zn-, and Cd-NPs can store 27, 22, and 15 wt % of CO 2 at 298 K and 9 atm., respectively. Then, Ni-and Cd-NPs are excellent for CO 2 storage, and Cd-NP is good for gas cleaning.
In the course of the last years hexacyanoferrates have been widely studied; even though, the adsorption properties of Zn (II) hexacyanoferrate(II) (labeled here Zn-HII) has not been thoroughly considered. In addition, soft porous crystals, i.e., adsorbents that display structural flexibility have been, as well, extensively studied, however this property has not been reported for Zn (II) hexacyanoferrate(II). In this regard, the key questions addressed here were the synthesis and structural characterization of Zn-HII together with the investigation of their low (up to 1 Bar) and high pressure (up to 30 Bar) adsorption properties, to found if these materials show structural flexibility. Then, to attain the anticipated goals, structural characterizations were made with: X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive Xray analysis (EDAX), diffuse reflectance infrared Fourier transform spectrometry (DRIFTS) and thermo-gravimetric analysis (TGA), simultaneously, with the investigation of the adsorption of carbon dioxide. As a result of the research process we concluded that the Zn-HII displayed m Fm3 space group framework. Besides, the carbon dioxide adsorption investigation demonstrated the presence of the framework expansion effect together with an extremely high adsorption heat, properties that could be useful for the use of Zn(II) hexacyanoferrate(II) as an excellent adsorbent.
The key questions addressed here were: the structure elucidation and the investigation of the adsorption space and framework expansion effect of a Cu(II) hexacyanoferrate (III) polymorph (labelled Cu-PBA-I). The structural analysis was performed with a broad set of characterization methods. Additionally, a low and high pressure carbon dioxide adsorption investigation was performed, assuming, to comprehend the adsorption experiments, that the adsorbent plus the adsorbed phase were a solid solution. We concluded: that the Cu-PBA-I presented the following composition, the isosteric heat of adsorption, q iso = 19 kJ/mol; further, the high pressure adsorption data revealed an extremely high adsorption capacity owing to a framework expansion effect. Finally, the DRIFTS spectrum of adsorbed CO 2 displayed peaks corresponding to carbon dioxide physically adsorbed and interacting with electron accepting Lewis acid sites. Hence, was produced an excellent adsorbent which combine porosity and anti-ferromagnetism, antagonist properties rarely found together.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.