Lightweight Unmanned Aerial Vehicles (UAVs) have become a cost effective alternative for studies which use aerial Remote Sensing with high temporal frequency requirements for small areas. Laser scanner devices are widely used for rapid tridimensional data acquisition, mainly as a complementary data source to photogrammetric surveying. Recent studies using laser scanner systems onboard UAVs for forestry inventory and mapping applications have presented encouraging results. This work describes the development and accuracy assessment of a low cost mapping platform composed by an Ibeo Lux scanner, a GNSS (Global Navigation Satellite System) antenna, an Inertial Navigation System Novatel Span-IGM-S1, integrating a GNSS receiver and an IMU (Inertial Measurement Unit), a Raspberry PI portable computer and an octopter UAV. The system was assessed in aerial mode using an UAV octopter developed by SensorMap Company. The resulting point density in a plot with trees concentration was also evaluated. The point density of this device is lower than conventional Airborne Laser Systems but the results showed that altimetric accuracy with this system is around 30 cm, which is acceptable for forest applications. The main advantages of this system are their low weight and low cost, which make it attractive for several applications.

ABSTRACT:Unmanned Aerial Vehicles (UAV) have been recognized as a tool for geospatial data acquisition due to their flexibility and favourable cost benefit ratio. The practical use of laser scanning devices on-board UAVs is also developing with new experimental and commercial systems. This paper describes a light-weight laser scanning system composed of an IbeoLux scanner, an Inertial Navigation System Span-IGM-S1, from Novatel, a Raspberry PI portable computer, which records data from both systems and an octopter UAV. The performance of this light-weight system was assessed both for accuracy and with respect to point density, using Ground Control Points (GCP) as reference. Two flights were performed with the UAV octopter carrying the equipment. In the first trial, the flight height was 100 m with six strips over a parking area. The second trial was carried out over an urban park with some buildings and artificial targets serving as reference Ground Control Points. In this experiment a flight height of 70 m was chosen to improve target response. Accuracy was assessed based on control points the coordinates of which were measured in the field. Results showed that vertical accuracy with this prototype is around 30 cm, which is acceptable for forest applications but this accuracy can be improved using further refinements in direct georeferencing and in the system calibration.

Synchronization of airborne laser scanning devices is a critical process that directly affects data accuracy. This process can be more challenging with low-cost airborne laser scanning (ALS) systems because some device connections from off-the-shelf sensors are less stable. An alternative to synchronization is performing a postprocessing clock correction. This article presents a technique for postprocessing synchronization (off-line) that estimates clock differences based on the correlation between the signals from the global navigation satellite system (GNSS) trajectory and the light detection and ranging (lidar) range, followed by refinement with a least-squares method. The correlation between signals was automatically estimated considering the planned flight maneuvers, in a flat terrain, to produce altimetric trajectory variations. Experiments were performed with an Ibeo LUX laser unit integrated with a NovAtel SPAN-IGM-S1 inertial navigation system that was transported by an unmanned aerial vehicle (UAV). The planimetric and altimetric accuracies of the point cloud obtained with the proposed postprocessing synchronization technique were 28 cm and 10 cm, respectively, at a flight height of 35 m.