No abstract

No abstract

This paper describes the development of an alternative technology for storing hydrogen fuel onboard automobiles. Insulated pressure vessels are cryogenic-capable pressure vessels that can accept cryogenic liquid fuel, cryogenic compressed gas or compressed gas at ambient temperature. Insulated pressure vessels offer advantages over conventional H 2 storage approaches. Insulated pressure vessels are more compact and require less carbon fiber than GH 2 vessels. They have lower evaporative losses than LH 2 tanks, and are much lighter than metal hydrides.After outlining the advantages of hydrogen fuel and insulated pressure vessels, the paper describes the experimental and analytical work conducted to verify that insulated pressure vessels can be used safely for vehicular H 2 storage. The paper describes tests that have been conducted to evaluate the safety of insulated pressure vessels. Insulated pressure vessels have successfully completed a series of DOT, ISO and SAE certification tests. A draft procedure for insulated pressure vessel certification has been generated to assist in a future commercialization of this technology. An insulated pressure vessel has been installed in a hydrogen fueled truck and it is currently being subjected to extensive testing.2

No abstract

A multi-zone model has been developed that accurately predicts HCCI combustion and emissions. The multizone methodology is based on the observation that turbulence does not play a direct role on HCCI combustion. Instead, chemical kinetics dominates the process, with hotter zones reacting first, and then colder zones reacting in rapid succession. Here, the multi-zone model has been applied to analyze the effect of piston crevice geometry on HCCI combustion and emissions. Three different pistons of varying crevice size were analyzed. Crevice sizes were 0.26, 1.3 and 2.1 mm, while a constant compression ratio was maintained (17:1). The results show that the multi-zone model can predict pressure traces and heat release rates with good accuracy. Combustion efficiency is also predicted with good accuracy for all cases, with a maximum difference of 5% between experimental and numerical results. Carbon monoxide emissions are underpredicted, but the results are better than those obtained in previous publications. The improvement is attributed to the use of a 40-zone model, while previous publications used a 10zone model. Hydrocarbon emissions are well predicted. For cylinders with wide crevices (1.3 and 2.1 mm), HC emissions do not decrease monotonically as the relative air/fuel ratio (λ) increases. Instead, maximum HC emissions are obtained for an intermediate value of λ. The model predicts this relative air/fuel ratio for maximum HC emissions with very good accuracy. The results show that the multi-zone model can successfully predict the effect of crevice geometry on HCCI combustion, and therefore it has applicability to the design of HCCI engines with optimum characteristics for high efficiency, low emissions and low peak cylinder pressure.