Abstract. Mechanical test specimens were prepared from the cranial and caudal cortices of radii from eight horses. These were subjected to destructive tests in either tension or compression. The ultimate stress, elastic modulus and energy absorbed to failure were calculated in either mode of loading. Analysis was performed on the specimens following mechanical testing to determine their density, mineral content, mineral density distribution and histological type. A novel technique was applied to sections from each specimen to quantify the predominant collagen fibre orientation of the bone near the plane of fracture. The collagen map for each bone studied was in agreement with the previously observed pattern of longitudinal orientation in the cranial cortex and more oblique to transverse collagen in the caudal cortex. Bone from the cranial cortex had a significantly higher ultimate tensile stress (UTS) than that from the caudal cortex (160 MPa vs 104 MPa; P<0.001) though this trend was reversed in compression, the Caudal cortex becoming relatively stronger (185MPa vs 217MPa; P<0.01). Bone from the cranial cortex was significantly stiffer than that from the caudal cortex both in tension (22 GPa vs 15 GPa; P<0.001) and compression (19 GPa vs 15 GPa; P<0.01). Of all the histo-compositional variables studied, collagen fibre orientation was most closely correlated with mechanical properties, accounting for 71% of variation in ultimate tensile stress and 58% of variation in the elastic modulus. Mineral density and porosity were the only other variables to show any significant correlation with either UTS or elastic modulus. The variations in mechanical properties around the equine radius, which occur in close association with the different collagen fibre orientations, provide maximal safety factors in terms of ultimate stress, yet contribute to greater bending of the bone as it is loaded during locomotion, and thus lower safety factors through the higher strains this engenders.Correspondence to .' A. Boyde

Hardness and calcium content in compact bone are strongly related. Variation in Young's modulus is produced mainly by variations in mineralisation. Therefore, there should be a relationship between hardness and Young's modulus. We demonstrate this. The calcium content of cancellous bone and adjacent compact bone in several species shows little difference, the cancellous bone having approximately 10% less calcium. The hardness of cancellous bone in Bos is approximately 12% less than that of adjacent compact bone, and the calcium is approximately 2% less. These lines of evidence make it unlikely that the Young modulus of cancellous bone material is much different from that of compact bone. Similar evidence suggests that the yield stress of cancellous bone is similar to that of adjacent compact bone.

No abstract

A portable system using a direct contact for the measurement of ultrasonic velocity and broadband attenuation in bone is described (contact ultrasonic bone analyser, CUBA). Soft-tissue compensation is performed using an ultrasonic pulse-echo technique. CUBA has been successfully validated using reference materials, the precision of velocity and broadband attenuation measurements being typically 0.2% and 0.5% respectively. The clinical reproducibility has been assessed on the equine third metacarpal bone. The reproducibility of velocity measurement is typically 0.5% for cortical bone and 1% for cancellous bone. For broadband attenuation the reproducibility is typically 7% for cortical bone and 6% for cancellous bone. The lower reproducibility of the attenuation data is attributed to the high sensitivity to variations in the material properties of bone with small changes in transducer positioning. Coupling difficulties through an intact equine coat have been overcome and the system may now be assessed in the clinical environment, in both human and animal populations.

Summary The behaviour of cortical bone under load is strain rate‐dependent, i.e. it is dependent on the rate at which the load is applied. This is particularly relevant in the galloping horse since the strain rates experienced by the bone are far in excess of those recorded for any other species. In this study the effect of strain rates between 0.0001 and 1 sec‐1 on the mechanical properties of equine cortical bone were assessed. Initially, increasing strain rates resulted in increased mechanical properties. Beyond a critical value, however, further increases in strain rate resulted in lower strain to failure and energy absorbing capacity. This critical rate occurred around 0.1 sec−1 which is within the in vivo range for a galloping racehorse. Analysis of the stress‐strain curves revealed a transition in the type of deformation at this point from pseudo‐ductile to brittle. Bones undergoing brittle deformation are more likely to fail under load, leading to catastrophic fracture and destruction of the animal.