Organic and inorganic flocculants are used in treatment of water and industrial effluents. Polymeric flocculants, synthetic as well as natural, because of their natural inertness to PH changes, low dosage, and easy handling, have become very popular in industrial effluent treatment. It has been established in the authors' laboratory that by grafting polyacrylamide branches on rigid backbone of polysaccharides, the dangling grafted chains have easy approachability to contaminants in effluents. Thus grafted polysaccharides are very efficient, shear stable and biodegradable flocculants. They also exhibit turbulent drag reducing characteristics. Among grafted guar gum, xanthan gum, carboxymethyl cellulose, and starch, grafted starch performs the best. Starch consists of amylose (a low molecular weight linear polymer) and amylopectin (a high molecular weight, branched polymer). The grafted amylopectin is found to be the best flocculant for various kinds of industrial effluents, providing credibility to the above‐cited model. In the present paper, the details about grafted polysaccharides as turbulent drag reducers and flocculants are given, along with their applications.

No abstract

No abstract

No abstract

The Tripura state went through extensive geological tectonics that resulted in the creation of complex structural styles with different fault types, lineaments, and plate boundaries, which in turn caused possible zones with over-pressured formations characterized by higher seismic amplitude signatures. Without accurate estimates of pore pressures, drilling through these hazardous zones is very troublesome and could jeopardize the whole drilling rig site. Pore pressures are easily predicted for sediments with normal pressure gradient. The prediction of pore pressure for the abnormally pressured (i.e., overpressured) sediments is more difficult and more important. Understanding of the pore pressure is a requirement of the drilling plan in order to design a proper casing program. With balanced drilling mud, overpressured formations, and borehole instability will be effectively controlled while drilling and completing the well. Well control events such as formation fluid kicks, loss of mud circulation, surface blowouts, and subsurface kicks can be avoided with the use of accurate pore pressure and fracture gradient predictions in the design process. In this study, transform models using modified Eaton's method were used to predict pore pressures from seismic interval velocities. Corrected two-way travel times and average velocity values for 28 sorted common depth points were input into the transform for pore pressures prediction predicted pore pressures show a reasonable match when plotted against formation pressure data from the offset wells namely AD-4 trend, Agartala Dome-6. Ambasa trend, Kathalchari trend, Kubal, Masimpur-3, Rokhia structure-RO1, and Tichna structure-TI1. In this study, it is observed that overpressure starts at shallow depths (1,482-2,145 m) in synclinal section while in flank section it starts deeper (2,653-5,919 m) in Atharamura anticline. It is also observed that the most of wells showing pressure match are located in the western side of the Atharamura. The maximum predicted pore pressure gradient observed in this study is 1.03 psi/feet in both synclinal and flank sections of Atharamura anticline. Based on our observations, it is interpreted that Tripura region is characterized by single pressure source and the pressure is distributed evenly in all the anticlines in this region.