The purposes of this article were identification (ie, verification and gradation) of anatomical risk factors that lead to anterior cruciate ligament (ACL) injury and determination of the probability of ACL injury among the population actively engaged in sports activities. We evaluated 66 patients divided into 2 groups: 33 patients in the examined group diagnosed with ACL lesion, and 33 patients in the control group diagnosed with patellofemoral pain. Patients were matched by age, sex, type of lesion, and whether the lesion was left or right sided. Measurements were carried out by radiography and magnetic resonance imaging. The study examined 32 anatomical factors. After identifying factors that lead to ACL injury, the following were determined: the coefficient of significance for each individual factor via the discriminant analysis and the canonical discriminant (i.e., canonical correlation). Fifteen factors in men and 8 factors in women were differentiated as having influence on ACL injury. Based on these factors, it was determined whether the patients belonged to the examined or the control group with a success rate of 100% in men (100% sensitivity and specificity) and 91.7% in women (100% sensitivity and 83.3% specificity). The anatomy of the ACL prone to rupture and of the skeletal structures influencing it is significantly different from the anatomy of the ACL ligament resistant to injury. The probability of precise prognosis of ACL injury based on differentiated anatomical factors is 88.9% in men and 75.7% in women actively engaged in sports activities.

The most important anatomic risk factors in ACL lesions are the morphometric parameters of intercondylar notch. In the morphometric studies index of notch width and index of notch shape (NWI and NSI) are commonly used. The certain morphologic parameters of distal femoral part are used in calculation. Beside standard parameters we measured the maximal width of intercondylar notch and distal part of femur, which we used for calculation of maximal index of notch width and maximal index of notch shape (NWI max and NSI max). We compared two different methods of calculation of intercondylar notch indexes to find out which one represent anatomic risk factor and influence the ACL lesions. The indexes were measured in the two groups of patients (33) who have the history of knee injuries, the first group has document of ACL injuries and the second without ACL injuries (control one). The important difference between two groups was founded in NWI (p < 0.01) and NSI (p < 0.05). NWImax and NSImax do not show the difference (p > 0.05). The NWI and NSI importance is higher in males, and smaller in females. There is no difference in NWImax and NSImax (p > 0.05) comparing to the gender.

Femur's length increasing also produces increasing of absolute anatomical parametars of distal femur which can produce rupture of anterior cruciate ligament, while relative dimensions do not show femur's length increasing.

By the use of a set of parallel bars it is possible to measure the tibial slope directly without removal of the soft tissue. The results of indirect, photographic measurement did not statistically differ from the results of direct measurement of the tibial slope.

Background/Aim. The key to successful anterior cruciate ligament reconstruction lies in the proper positioning of the femoral tunnel within the anatomical footprint and in providing for an adequate length of this tunnel without perforation to the lateral cortex. The aim of this study was to determine the change in the length of the femoral tunnel drilled during anatomic anterior cruciate ligament (ACL) reconstruction, depending on: the position of the limb being operated on, the degree of knee flexion, as well as the angle between the drill and the medial aspect of the lateral condyle. Methods. This study was performed on 16 cadaveric knees (6 male and 10 female) of the average age of 83. After the subcutaneous tissue was dissected, the femoral insertion of the ACL was identified. Then, 18 tunnels were drilled through the center of the femoral insertion with the help of 2 mm thick Kirschner wires. This was performed in two stages. In the first phase the leg was positioned on an arthroscopic leg holder, while in the second phase the leg was positioned on the table. In each phase the knee was placed in three different flexion positions (110°, 120° and 130°) and for each position three tunnels were drilled (70°, 60° and 50°) in relation to the medial aspect of the lateral condyle. Results. The average length of the femoral tunnel