The bacteriochlorophyll (Bchl) c content and organization was determined for Chlorobium (Cb.) tepidum chlorosomes, the light-harvesting complexes from green photosynthetic bacteria, using fluorescence correlation spectroscopy and atomic force microscopy. Single-chlorosome fluorescence data was analyzed in terms of the correlation of the fluorescence intensity with time. Using this technique, known as fluorescence correlation spectroscopy, chlorosomes were shown to have a hydrodynamic radius (Rh) of 25 +/- 3.2 nm. This technique was also used to determine the concentration of chlorosomes in a sample, and pigment extraction and quantitation was used to determine the molar concentration of Bchl c present. From these data, a number of approximately 215,000 +/- 80,000 Bchl c per chlorosome was determined. Homogeneity of the sample was further characterized by dynamic light scattering, giving a single population of particles with a hydrodynamic radius of 26.8 +/- 3.7 nm in the sample. Tapping-mode atomic force microscopy (TMAFM) was used to determine the x,y,z dimensions of chlorosomes present in the sample. The results of the TMAFM studies indicated that the average chlorosome dimensions for Cb. tepidum was 174 +/- 8.3 x 91.4 +/- 7.7 x 10.9 +/- 2.71 nm and an overall average volume 90,800 nm(3) for the chlorosomes was determined. The data collected from these experiments as well as a model for Bchl c aggregate dimensions was used to determine possible arrangements of Bchl c oligomers in the chlorosomes. The results obtained in this study have significant implications on chlorosome structure and architecture, and will allow a more thorough investigation of the energetics of photosynthetic light harvesting in green bacteria.

We report a general procedure to prepare functional organic thin films for biological assays on oxide surfaces. Silica surfaces were functionalized by self-assembly of an amine-terminated silane film using both vapor- and solution-phase deposition of 3'-aminopropylmethyldiethoxysilane (APMDES). We found that vapor-phase deposition of APMDES under reduced pressure produced the highest quality monolayer films with uniform surface coverage, as determined by atomic force microscopy (AFM), ellipsometry, and contact angle measurements. The amine-terminated films were chemically modified with a mixture of carboxylic acid-terminated poly(ethylene glycol) (PEG) chains of varying functionality. A fraction of the PEG chains (0.1-10 mol %) terminated in biotin, which produced a surface with an affinity toward streptavidin. When used in pseudo-sandwich assays on waveguide platforms for the detection of Bacillus anthracis protective antigen (PA), these functional PEG surfaces significantly reduced nonspecific binding to the waveguide surface while allowing for highly specific binding. Detection of PA was used to validate these films for sensing applications in both buffer and complex media. Ultimately, these results represent a step toward the realization of a robust, reusable, and autonomous biosensor.

The B798 light-harvesting baseplate of the chlorosome antenna complex of the thermophilic, filamentous anoxygenic phototrophic bacterium Chloroflexus aurantiacus has been isolated and characterized. Isolation was performed by using a hexanol-detergent treatment of freeze-thawed chlorosomes. The isolated baseplate consists of Bchl a, beta-carotene, and the 5.7 kDa CsmA protein with a ratio of 1.0 CsmA protein/1.6 Bchl a/4.2 beta-carotenes. The baseplate has characteristic absorbance at 798 nm as well as carotenoid absorbance maxima at 519, 489, and 462 nm. The energy transfer efficiency from the carotenoids to the Bchl a is 30% as measured by steady-state and ultrafast time-resolved fluorescence and absorption spectroscopies. Energy equilibration within the Bchl a absorbing regions exhibits ultrafast kinetics. Circular dichroism spectroscopy shows no evidence for excitonically coupled Bchl a pools within the 798 nm region.

Lipopolysaccharide (LPS) is a unique lipoglycan, with two major physiological roles: 1), as a major structural component of the outer membrane of Gram-negative bacteria and 2), as a highly potent mammalian toxin when released from cells into solution (endotoxin). LPS is an amphiphile that spontaneously inserts into the outer leaflet of lipid bilayers to bury its hydrophobic lipidic domain, leaving the hydrophilic polysaccharide chain exposed to the exterior polar solvent. Divalent cations have long been known to neutralize and stabilize LPS in the outer membrane, whereas LPS in the presence of monovalent cations forms highly mobile negatively-charged aggregates. Yet, much of our understanding of LPS and its interactions with the cell membrane does not take into account its amphiphilic biochemistry and charge polarization. Herein, we report fluorescence microscopy and atomic force microscopy analysis of the interaction between LPS and fluid-phase supported lipid bilayer assemblies (sLBAs), as model membranes. Depending on cation availability, LPS induces three remarkably different effects on simple sLBAs. Net-negative LPS-Na(+) leads to the formation of 100-μm-long flexible lipid tubules from surface-associated lipid vesicles and the destabilization of the sLBA resulting in micron-size hole formation. Neutral LPS-Ca(2+) gives rise to 100-μm-wide single- or multilamellar planar sheets of lipid and LPS formed from surface-associated lipid vesicles. Our findings have important implications about the physical interactions between LPS and lipids and demonstrate that sLBAs can be useful platforms to study the interactions of amphiphilic virulence factors with cell membranes. Additionally, our study supports the general phenomenon that lipids with highly charged or bulky headgroups can promote highly curved membrane architectures due to electrostatic and/or steric repulsions.