For workplaces where significant diurnal variations in radon concentrations are likely, measurements to evaluate average radon concentration during working hours could be useful for planning an optimized protection of workers according to the 2013/59/Euratom Directive. However, very few studies on this subject, generally limited to periods of few weeks, have been published. Therefore, a study has been conducted to evaluate the actual long-term radon exposure during working hours for a sample of 33 workplaces of four different types (postal offices, shops, restaurants, municipal offices), mainly located at the ground floor, and with expected considerable air exchange rate occurring during working hours due to frequent entrance/exit of persons or mechanical ventilation. The results show that the difference between the average radon level during working hours and that one during the whole day is about 20% on average and ranges from 0 to 50%. These observed differences, generally smaller compared with those found in other similar studies, are nearly the same if the analysis is restricted to workplaces with annual radon level higher than 300 Bq m–3, and therefore natural or mechanical ventilation normally present during working hours of the monitored workplaces cannot be considered an effective mitigation measure. However, the costs and time-response characteristics of the active monitors, as those used for the present study, will probably allow using more frequently a similar measurement strategy in workplaces.

Extensive radon surveys have been carried out in many countries only in dwellings, whereas surveys in workplaces are rather sparse and generally restricted to specific workplaces/activities, e.g. schools, spas and caves. Moreover, radon-prone areas are generally defined on the basis of radon surveys in dwellings, while radon regulations use this concept to introduce specific requirements in workplaces in such areas. This approach does not take into account that work activities and workplace characteristics can significantly affect radon concentration. Therefore, an extensive survey on radon in different workplaces have been carried out in a large region of Italy (Tuscany), in order to evaluate radon distribution in workplaces over the whole territory and to identify activities and workplace characteristics affecting radon concentration. The results of this extensive survey are compared with the results of the survey carried out in dwellings in the same period. The workplaces monitored were randomly selected among the main work activities in the region, including both public and industrial buildings. The survey monitored over 3500 rooms in more than 1200 buildings for two consecutive periods of ∼6 months. Radon concentration was measured by means of passive nuclear track detectors.

The interest in radiation protection in industrial sectors involving Naturally Occurring Radioactive Materials (NORM) is increasingly growing. This is due also to the recent implementation of the European Council Directive 59/2013/Euratom which in Italy and in the other European Union Member States extends the field of application to industrial sectors never involved before. This paper reports main results of a research project on radiation protection in industries involving NORM carried out in Italy aimed to provide useful tools for stakeholders to comply new legal obligations. The project activities were mainly focused on different aspects relevant to the NORM involving industries, accounting for the positive list reported in the Italian law. Firstly, the inventory of the industries currently operating in Italy in order to identify the industrial sectors with an important radiological impact on population and workers was updated. Based on this information, a general methodology was elaborated taking into account a graded approach. The first phase consists in the identification and characterization of the most critical exposure scenarios and of the radiological content of NORMs involved in the different phases of the industrial processes. In the second phase calculation methods were developed for dose estimation for workers and members of public. These tools require the use of existing and well tested calculation codes, and the development of a dedicated user-friendly software.