Three different levels of autohydrolysis intensity, expressed as the prehydrolysis (P)-factor, were applied to Eucalyptus globulus wood at a liquor/wood ratio of 5:1. Lignin fractions were isolated from the wood residue as milled wood lignin (MWL), from the hydrolysate by centrifugation (insoluble fraction) and by ethyl acetate extraction (soluble fraction), and from the reactor wall as precipitate. With increasing autohydrolysis duration, a decrease in the content of aliphatic hydroxyl groups and of β-O-4 structures was detected in all lignin fractions, whereas the content of phenolic hydroxyl groups increased in the same order. MWL isolated from wood residue after autohydrolysis at the highest P-factor contained only half the β-O-4 structures contained in native lignin. Molecular weight distribution measurements revealed that fragmentation reactions dominated over condensation reactions in all lignin samples investigated. However, low-molecular-weight lignin dissolved in autohydrolysate exhibited extremely high reactivity towards acid-catalysed condensation reaction, which inevitably leads to the formation of sticky precipitates during storage at elevated temperature under the acid conditions prevailing.

The effect of autohydrolysis of Eucalyptus globulus wood was studied with regard to conditions applied in a prehydrolysis-kraft process on the physico-chemical properties of lignin obtained in both the wood residue and hydrolysate. As a reference, milled wood lignin (MWL) was isolated from native wood and compared to three lignin fractions formed during prehydrolysis: 1) lignin from the wood residue isolated as MWL, 2) lignin precipitated from the prehydrolysate during cooling and separated by centrifugation, and 3) lignin degradation products soluble in the prehydrolysate extracted with ethylacetate. All lignin fractions were subjected to Fourier transform infrared (FTIR) spectroscopy, methoxy group determination, elemental analysis, size exclusion chromatography and quantitative nuclear magnetic resonance (NMR) spectroscopy. The results indicate that extensive lignin degradation occurs during prehydrolysis through homolytic cleavage of the aryl-ether bonds resulting in a substantial molecular weight loss of the residual lignin in the treated wood and in the lignin fractions isolated from the prehydrolysate. The aryl-ether cleavage is coupled with a strong increase in phenolic hydroxyl groups and a decrease in aliphatic hydroxyl groups. Indication for condensation reactions were found by NMR spectroscopy.

No abstract

Subcritical water is a high potential green chemical for the hydrolysis of cellulose. In this study microcrystalline cellulose was treated in subcritical water to study structural changes of the cellulose residues. The alterations in particle size and appearance were studied by scanning electron microscopy (SEM) and those in the degree of polymerization (DP) and molar mass distributions by gel permeation chromatography (GPC). Further, changes in crystallinity and crystallite dimensions were quantified by wide-angle X-ray scattering and (13)C solid-state NMR. The results showed that the crystallinity remained practically unchanged throughout the treatment, whereas the size of the remaining cellulose crystallites increased. Microcrystalline cellulose underwent significant depolymerization in subcritical water. However, depolymerization leveled off at a relatively high degree of polymerization. The molar mass distributions of the residues showed a bimodal form. We infer that cellulose gets dissolved in subcritical water only after extensive depolymerization.

Herein we describe a possibility of selective dissolution of xylan, the most important type of hemicellulose, from Eucalyptus globulus kraft pulp using ionic liquids (ILs). On the basis of the IL 1-butyl-3-methylimidazolium dimethyl phosphate, which is well-known to dissolve pulp, the phosphate anion was modified by substituting one oxygen atom for sulfur and selenium, respectively. This alteration reduces the hydrogen bond basicity of the IL and therefore prevents dissolution of cellulose fibers, whereas the less ordered xylan is still dissolved. (1)H NMR spectra of model solutions and Kamlet-Taft parameters were used to quantify the solvent polarity and hydrogen bond acceptor properties of the ILs. These parameters have been correlated to their ability to dissolve xylan and cellulose, which was monitored by (13)C NMR spectroscopy. It was found that the selectivity for xylan dissolution increases to a certain extent with decreasing hydrogen-bond-accepting ability of anions of the ILs.