This work aims to produce poly(ethylene terephthalate)/multilayer graphene oxide (mGO) nanocomposites via continuous melt mixing in twin-screw extrusion, and to study the changes in crystallization and melt flow behavior. Three mGO contents (0.05, 0.1, and 0.3 wt%) were used. Differential scanning calorimetry analyses showed that at 0.1 wt%, mGO acted best as nucleating agent, increasing the crystallization kinetics as well as the melt crystallization temperature (T mc) by more than 20%. It was also observed that mGO increases the crystals perfection. The nucleating behavior was confirmed by X-ray diffraction and small angle X-ray scattering analyses, which showed a decrease in the composites' crystalline lamella thickness (l c) and long period. X-ray microtomography data confirms that this behavior is significantly affected by the mGO agglomerates distribution and specific surface area inside the polymer matrix. The rheological behavior was studied under two different conditions. It was noticed that under lower shear stresses the mGO particles hinder the polymer flow, increasing the composites viscosity and the pseudo-solid character. However, under higher shear stresses, for example, when flowing through a die, the nanomaterial enters its "superlubricity state," acting as a lubricant to the flow. This is industrially interesting, because it may allow the use of less severe processing parameters to produce the nanocomposites.

There is great interest in the use of graphene and derivatives in the production of polymer nanocomposites as it provides improvements in the properties of the materials to which they are associated. Such improvements depend heavily on filler dispersion and the interaction between the nanomaterials and the matrix. This work aimed to study the compatibility of graphene oxide (GO) with a poly(ethylene terephthalate) matrix. For this, graphite was modified using Hummers method, using reaction times of 3 and 6 h. The obtained GO was functionalized with amine, amide, and magnetite groups (FGO). The effects of the oxidation degree, functionalization and concentration of the nanofillers on the dispersion and consequently on the properties of the polymer nanocomposites were evaluated. The nanocomposites were synthesized by the solid–solid deposition method followed by the melt mixing technique. It was observed that lower concentrations of nanofiller associated with the lower degree of oxidation and functionalization improved the interaction of the nanofillers with the matrix, which resulted in better mechanical properties under tensile stresses for strain at break, maximum stress, Young's modulus and toughness. It was also observed that the glass transition and crystallization of nanocomposites increased due to a nucleating effect of the nanofillers.

No abstract