The ZW sex chromosomes of the European eel, Anguilla anguilla, and the American eel, A. rostrata, were examined with C-band and fluorescent staining to demonstrate the C-band heterochromatin. The W as well as Z chromosomes in both species are C-band negative except for a small amount of C-band heterochromatin in the centromeric region, in contrast to the W or Y elements of most other vertebrates. No fluorescing W-associated body is evident either in interphase nuclei or in metaphase plates. The ZW chromosomes of the two species have substantially similar size, morphology, and patterns of C-band heterochromatin. Karyologic and evolutionary implications are discussed.

No abstract

No abstract

The carcinogenic potential in the intraperitoneal cavity of three newly developed biosoluble insulation glass wool fibers (M, P, and V) and one newly developed biosoluble insulation stone wool fiber (O) was investigated and compared to that of a previously developed soluble glass fiber (B). The in vitro dissolution coefficient of the three glass wool fibers ranged from 450 to 1037 ng/cm(2) x h and was 523 ng/cm(2) x h for the stone wool fiber. The in vitro dissolution coefficient of the B fiber was 580 ng/cm(2) x h. Groups of female Wistar rats (strain Crl: Wi BR) were exposed by repeated injections to doses of 0.5, 2, and 5 x 10(9) WHO fibers, which corresponds to between 41 mg to 724 mg fiber injected. In addition, 2 groups of crocidolite were used as positive controls at doses of 0.1 x 10(9) and 1 x 10(9) WHO fibers (0.5 and 5 mg). The in vitro dissolution coefficient of crocidolite is estimated to be approximately 1 ng/cm(2) x h. The protocol of the study and the size distribution of the test samples conformed to the European Commission Protocol EUR 18748 EN, and the study was executed under Good Laboratory Practice conditions. Two of the new insulation wools, fibers M and 0, showed no statistically significant tumorigenic response even at the very high dose of 5 x 10(9) WHO fibers injected. Fibers P and V showed a small tumorigenic response in the ip cavity similar in magnitude to the B fiber, which has been declared in the German fiber regulations as a noncarcinogenic fiber. The response to the soluble insulation fibers was notably different from that of the known carcinogen crocidolite, which produced 53% tumors at a comparatively low dose of 0.1 x 10(9) WHO fibers. The incidence of mesothelioma was found to be highly correlated to the incidence of intra-abdominal nodules and masses at different sites. The incidence of abdominal nodules and masses was highly correlated to the number of animals with ascites. The incidence of chronic peritonitis with fibrotic nodules at different organs also correlated with the incidence of mesotheliomas. Differences in etiology were observed between the massive doses of the highly soluble insulation wools when injected directly into the ip cavity and the lower doses of the extremely insoluble fiber crocidolite. The variability in this reaction and the impairment of animal health put into question the value of these massive doses in evaluating the carcinogenic response of soluble insulation wools. All of the fibers tested fulfilled the exoneration criteria with respect to carcinogenicity according to the European Directive 97/69/EC ("an appropriate intra-peritoneal test has not expressed signs of excessive carcinogenicity"). The dose as defined in the EC-Protocol EUR 18748 EN was 1 x 10(9) WHO fibers with a defined geometric spectrum. The influence of fiber dimensions on the ip tumor response and the difficulty in assessing the influence of the difference in background levels between this and previous studies make direct application of the German TRGS 905 criteria difficult;...

Neben dem heute in vielen Fertigungsbereichen eingeführten Fügeverfahren des Elektronenstrahlschweißens kann der Elektronenstrahl für eine thermische Behandlung in eng begrenzten Werkstückbereichen eingesetzt werden. Das Ziel einer solchen Behandlung ist beispielsweise ein sich nach sehr rascher Erstarrung bildendes Gefüge mit spezifischen Eigenschaften (Härte, Feinkörnigkeit) und die Verwirklichung bestimmter Legierungszusammensetzungen in eng begrenzten Bereichen. Zusatzmaterial in Drahtform wird hierzu während des Schweißprozesses zugegeben. Einsatzmöglichkeiten werden an Aluminium, Nickel und Stahl aufgezeigt.