An analysis technique, based on simulated annealing, is described which is employed to derive megavoltage photon beam spectral information from narrow beam attenuation measurements. Megavoltage photon beam spectra have been determined using this technique for linear accelerators from different manufacturers, and different models from individual manufacturers at a range of energies from nominal 6 MV to nominal 25 MV. All of the photon beams included in the study are in routine clinical use. The subsequent effects on dosimetry of employing derived primary spectra to specify beam quality are examined. The results suggest that the quality index TPR(20)10 may be insensitive to beam quality changes for high-energy beams in the range of 15 MV to 25 MV. Although the quality index may be insensitive as a beam quality specifier at these higher qualities, the actual difference in the calculated dose delivered using derived spectra as the quality specifier rather than TPR(20)10 is likely to be small, the results obtained indicating a difference of between 0.2% and 0.7% in the calculated dose delivered.

An important part of determining the radiation protection requirements during X-ray room design is the calculation of the amount of scatter inside and outside the planned locations of the shielding barriers. In this work, a Monte Carlo code has been developed to calculate the percentage scatter so that the current data can be consolidated and new data can be provided as required. Calculations have been compared with measurements to show that they are representative of scatter found in X-ray rooms. Scatter from the dose-area product meter and the collimator system were found to provide large contributions to the measured scatter. A fluoroscopy room containing a C-arm X-ray set was modelled with the Monte Carlo code. The scatter dose was calculated at an X-ray room entrance behind the protective screen, acting as a secondary barrier, at the radiographer's console. The variation of scatter with the position of the protective screen was studied. An empirical calculation, which provided reasonable agreement with the Monte Carlo calculations, was found by using new data for the variation of scatter from concrete with field size. If a door was placed in the X-ray room entrance behind the protective screen, the results showed that it would not need to be lead lined.

Calibration of patient dose monitoring devices in diagnostic radiology has become increasingly important in the light of new legislation that requires monitoring of patient dose against local and national diagnostic reference levels. An investigation was conducted into the long-term stability of 41 dose-area product (DAP) meters over a period of approximately 5 years, to assess the suitability of an annual calibration regimen. For DAP meters fitted to overcouch X-ray tubes, 77% of calibrations were within 10%, whilst for undercouch tubes only 50% of calibrations were within 10%. These findings suggest that annual calibration may be too infrequent. Suitable calibration frequencies for different clinical workloads are discussed.

No abstract

No abstract