Wind-driven power harvestings attract attentions since their target wind speeds are quite low less than the so-called cut-in wind speed, which is generally recognized as around 3 m/s. The extant power harvestings driven by wind-induced-air-column-resonations (i.e. acoustic-pressures) are still lacking simplicity, scale flexibility and solid strategies for practical applications. Therefore, the piezoelectric power harvesters via acoustic-pressures driven by low-speedwind-forces with resonating-tubes and wind-collectors were invented so as to complement all the lacks. The wind-collector as well as the resonating-tube contributed to upraise the power harvesting density. The champion power harvesting density of 19.5 nW/dm 2 could be procured at 2.3 m/s of an artificial wind and the optimal resonating-tube and wind-collector. Power harvesting proofs from the natural wind with low mean speeds down to about 0.6 m/s were successfully obtained. The cut-in wind speed of the prototype piezoelectric power harvester was found to be quite low as about 0.4 m/s, signifying its ubiquity. Finally, a multi-bundle pendant-type piezoelectric power harvester was specifically presented together with professing the solid and multiple strategies for practical applications.

In order to realize further stability of a stack-type thermoelectric power generating module (i.e. no electrical connections inside), flexible materials of metal springs and/or rods having restoring forces were installed between lower-temperature-sides of thermoelectric elements. These flexible materials were expected to play three important roles of interpolating different thermal expansions of the module components, enlarging heat removal area and penetration of any media through themselves. Then, a low-boiling-point medium (i.e. NOVEC manufactured by 3M Japan Ltd.) was also applied for a high-speed direct heat removal via its phase change from the lower-temperature-sides of the thermoelectric elements in the proposing stack-type thermoelectric power generating module. No electrical disconnections inside the module were confirmed for more than 9 years of use, indicating further module stability. The power generating density was improved to about 120 mW•m −2 with SUS304 springs having 0.7 mm diameter. Increasing power generating density can be expected in terms of suitable selection of flexible metal with high Vickers hardness, cavities control on the spring surface, more vigorous multiphase flow with adding powders to the medium and optimization of the module configurations according to numerical simulations.

Low-temperature thermal energy conversions down to exergy zero to electric power must contribute energy sustainability. That is to say, reinforcements of power harvesting technologies from extremely low temperatures less than 373 K might be at least one of minimum roles for the current generations. Then, piezoelectric power harvesting process for recovering low-temperature heats was invented by using a unique biphasic operating medium of an underlying water-insoluble/low-boiling-point medium (i.e. NOVEC manufactured by 3M Japan Ltd.) in small quantity and upper-layered water in large quantity. The higher piezoelectric power harvesting densities were naturally revealed with an increase in heating temperatures. Excessive cooling of the operating medium deteriorated the power harvesting efficiency. The denser operating medium was surpassingly helpful to the higher piezoelectric power harvesting density. Concretely, only about 5% density increase of main operating medium (i.e. water with dissolving alum at 0.10 mol/dm 3) came to the champion piezoelectric power harvesting density of 92.6 pW/dm 2 in this study, which was about 1.4 times compared to that with the original biphasic medium of pure water together with a small quantity of NOVEC.