Study on alternative methods to hydrodesulfurization is always an interesting area, because of the ineffectiveness for hydrodesulfurization to remove some cyclic sulfur compounds (S-compounds) and the high cost from harsh operation conditions and expensive catalyst, among which oxidative desulfurization (ODS) using ionic liquids (ILs) as solvent is intensively studied recently. Here, we synthesize a series of Brønsted–Lewis acidic ILs of N-methylpyrrolidonium zinc chloride ([Hnmp]­Cl x /(ZnCl2) y , x:y from 2:1 to 1:2) and investigate the ODS of both model diesel fuel composed of n-octane and dibenzothiophene and real FCC feedstock where such ILs are used as extractant and catalyst and 30 wt % H2O2 is used as oxidant, involving the factors such as IL composition (or x:y), temperature, dose of oxidant (or molar ratio of O/S), dose of IL (or mass ratio of IL/oil), recycling of IL and multistage desulfurization. IL composition has an important effect on sulfur removal (S-removal) efficiency, and [Hnmp]­Cl/ZnCl2 (x:y = 1, the structure nature was characterized with ESI-MS and FT-IR) shows the highest desulfurization capability with good recyclability. With [Hnmp]­Cl/ZnCl2, the S-content in model diesel fuel can be reduced to <1 ppm from 500 ppm with 99.9% S-removal at 75 °C, IL/oil = 1/3 and O/S = 8 after only one stage, while the sulfur removal for real FCC diesel fuel is less than 38% in one stage and can reach 83% after five stages, which might be ascribed to more-complex S-species in real fluidized catalytic cracking (FCC) diesel fuel as indicated by gas chromatography–sulfur chemiluminescence detection (GC-SCD) chromatogram analyses. The sulfur content (S-content) in FCC diesel fuel, however, can be reduced to 5.3 ppm with a total S-removal of 97.6% after five-stage ODS with one more extractive desulfurization with furfural as the extractant. This work shows that such Brønsted–Lewis acidic ILs are potential solvents used in ODS to produce clean fuel oils.

No abstract

The high density of defects in MAPbI3 perovskite films brings about severe carrier nonradiative recombination loss, which lowers the performance of MAPbI3-based perovskite solar cells (PSCs). Here, methylamine cyanate (MAOCN) molecules were introduced into MAPbI3 solutions to manipulate the crystallizatsion of the MAPbI3 films. MAOCN molecules can slow down the volatilization rate of the solvent and delay the crystallization process of the MAPbI3 film. The crystal quality of the MAPbI3 films is effectively optimized without an additive residue. Perovskite films treated by MAOCN have lower defect density and longer carrier lifetime, which lowers the carrier recombination loss. Meanwhile, the MAPbI3 film based on MAOCN has a more hydrophobic surface. The final MAPbI3-based device efficiency reached 21.28% (V OC = 1.126 V, J SC = 23.29 mA/cm2, and FF = 81.13). After 30 days of storage under atmospheric conditions, the efficiency of unencapsulated MAOCN-based PSCs only dropped by about 5%.

The interface between the electron transport layer (ETL) and the perovskite film plays a vital role for the performance of perovskite solar cells (PSCs). Here, (2-hydroxyethyl)amine hydroiodide (EOAI) is employed...

No abstract