Lateral resolution in confocal microscope is limited by the size of pinhole. In this paper, we attempt to introduce a new method to achieve structured detection through using spatial light modulator (SLM) to improve it. SLM modulates the Airy disk amplitude distribution according to the detection function in collection arm. Instead of using CCD to capture spot images and modulate them with numerical analysis in virtual structured detection (VSD), this method uses SLM to accomplish these aims with higher imaging rates. Based on simulation and the experiment results, it can be found that coherent transfer function expands and the resolution is 1.6 times as large as that of conventional confocal microscope.

In this paper, an assembled cantilever fiber touch trigger probe was developed for three-dimensional measurements of clear microstructures. The probe consists of a shaft assembled vertically to an optical fiber cantilever and a probing sphere located at the free end of the shaft. The laser is emitted from the free end of the fiber cantilever and converges on the photosensitive surface of the camera through the lens. The position shift of the light spot centroid was used to detect the performance of the optical fiber cantilever, which changed dramatically when the probing sphere touched the objects being measured. Experimental results indicated that the sensing system has sensitivities of 3.32 pixels/μm, 1.35 pixels/μm, and 7.38 pixels/μm in the x, y, and z directions, respectively, and resolutions of 10 nm, 30 nm, and 5 nm were achieved in the x, y, and z, respectively. An experiment on micro slit measurement was performed to verify the high aspect ratio measurement capability of the assembled cantilever fiber (ACF) probe and to calibrate the effective two-point diameter of the probing sphere. The two-point probe sphere diameter was found to be 174.634 μm with a standard uncertainly of 0.045 μm.

No abstract

No abstract