Achieving high-quality, relaxed InGaN substrates for longer-wavelength light emitting diodes (LEDs) is of great interest for the development of micro-LED based display technology. This work demonstrates molecular beam epitaxy (MBE)-grown In0.2Ga0.8N with a strain relaxation of 60% corresponding to an equivalently fully relaxed In composition of 12%. This was done by growing on a GaN-on-porous GaN pseudo-substrate (PS). The surface morphology of this film was found to be free of V-defects on the surface and with a threading dislocation density comparable to that of the GaN layers beneath. While InGaN grown on planar GaN-on-sapphire substrates remained nearly strained to the GaN underlayer, InGaN grown under identical conditions on PS displayed elastic-like relaxation. Furthermore, an increase in indium (In) composition was observed for the InGaN grown on PS. Where past work of InGaN grown on porous GaN PS by metalorganic chemical vapor deposition also resulted in relaxed InGaN templates suitable for device application, the surfaces of these relaxed films exhibited V-defects for thicker layers. Employing MBE, thicker films with higher In composition can be achieved with smooth surface morphology, thus enabling pseudo-substrates with a wide range of lattice constants. These pseudo-substrates of varying in-plane lattice constant are attractive for III-nitride based optoelectronics, particularly for green, amber, and red micro-LEDs.

In this article, N-polar GaN-on-sapphire deep-recess metal-insulator-semiconductor (MIS)-highelectron-mobility transistors (HEMTs) with a breakthrough performance at W-band are presented. Compared with prior N-polar GaN MIS-HEMTs, a thin GaN cap layer and atomic layer deposition (ALD) ruthenium (Ru) gate metallization were used along with high-quality GaN-on-sapphire epitaxy from Transphorm Inc. Before SiN passivation, 94 GHz large signal load-pull shows that the transistor obtains a recordhigh 9.65 dB linear transducer gain and demonstrated 42% power-added efficiency (PAE) with associated 4.4 W/mm of output power density at 12 V drain bias. By biasing the drain at 8 V, the device shows an even higher PAE of 44% with an associated 2.6 W/mm of output power density. After SiN passivation, the fabricated N-polar GaN-on-sapphire HEMTs show a high PAE of 40.2% with an associated 4.85 W/mm of output power density. Furthermore, a very high output power density of 5.83 W/mm with 38.5% PAE is demonstrated at a 14 V drain bias. This power performance shows significant efficiency improvement over previous N-polar GaN-on-SiC and demonstrates a combined efficiency and power density beyond what has been reported for Ga-polar devices, in spite of the low-thermal-conductivity sapphire substrate. This shows that N-polar GaN-on-sapphire technology is an attractive candidate for millimeter-wave power amplifier applications with simultaneous high efficiency and power density.

No abstract

This work investigates the process of planar electrochemical etching of pores in n-type nitrogen-polar GaN and the effect of pore morphology on regrown GaN film surface quality. An increase in the anodization voltage was found to increase the pore diameter and reduce the density of pores with inclined sidewalls near the surface of the porosified films. Simultaneously, a decrease in the hexagonal hillock size and number following GaN regrowth was observed. It is proposed that vertical pore sidewalls are essential to demonstrate high quality film coalescence. For smooth hillock-free 100 nm GaN regrowth, an optimal bias of 17 and 13 V for Ti-contacted N-polar GaN:Si with a Si doping of 4.5 × 1018 and 8 × 1018 cm−3, respectively, was found.

No abstract