Infections caused by drug-resistant pathogens are rapidly increasing in incidence and pose an urgent global health concern. New treatments are needed to address this critical situation while preventing further resistance...

The advent of nanotechnology has opened the possibility of fabricating nanoscopic pillars on the surface of polymeric films mimicking the Gecko's foot, in an attempt to increase their adhesive capabilities enhanced by van der Waals forces. However, these forces are considerably weakened in a wet physiological environment. To circumvent this loss in force, current biocompatible adhesives with nanopillars require complex multiple-step fabrication, including an extra layer of adhesive coating to stabilize tissue bonding under physiological conditions. In this report, we describe a simple one-step fabrication process of a single-layer chitosan film that has pillars with base diameter in the range of 100-600 nm and a height of~70 nm. The nanostructured adhesive is laser-bonded to tissue and does not require pillar coating to enhance bonding in water. In comparison with a 'flat' adhesive (without pillars), the nanostructured adhesive bonded significantly stronger to tissue under either stress or pressure. Atomic force spectroscopy also confirmed the superior bonding capability of the nanostructured adhesive. This study demonstrates a one-step fabrication technique to produce a monolayer gecko-inspired adhesive that is biocompatible and bonds effectively to tissue.

No abstract

Photochemical tissue bonding with chitosan-based adhesive films is an experimental surgical technique that avoids the risk of thermal tissue injuries and the use of sutures to maintain strong tissue connection. This technique is advantageous over other tissue repair methods as it is minimally invasive and does not require mixing of multiple components before or during application. To expand the capability of the film to beyond just a tissue bonding device and promote tissue regeneration, in this study, we designed bioadhesive films that could also support stem cells. The films were modified with oligomeric chitosan to tune their erodibility and made porous through freeze-drying for better tissue integration. Of note, porous adhesive films (pore diameter ∼110 μm), with 10% of the chitosan being oligomeric, could retain similar tissue bonding strengths (13−15 kPa) to that of the nonporous chitosan-based adhesives used in previous studies when photoactivated. When tested in vitro, these films exhibited a mass loss of ∼20% after 7 days, swelling ratios of ∼270−300%, a percentage elongation of ∼90%, and both a tensile strength and Young's modulus of ∼1 MPa. The physical properties of the films were suitable for maintaining the viability and multipotency of bone-marrow-derived human mesenchymal stem cells over the duration of culture. Thus, these biocompatible, photoactivated porous, and erodible adhesive films show promise for applications in controlled cell delivery and regenerative medicine.