Abstract. Experimental phase equilibria have been investigated on three medium-K silicic andesite (60-61 wt % SiO2) samples from Mount Pelhe at 2-4 kbar, 850-1040øC, under both vapor-saturated CO2-free and vapor-saturated CO2-bearing conditions. Most experiments were crystallization experiments using dry glasses prepared from the natural rocks. Both normal-and rapid quench experiments were performed. Two ranges of oxygen fugacity (fo2) were investigated: NNO (Ni-NiO buffer) to NNO + 1 and NNO + 2 to NNO + 3. At 2 kbar for moderately oxidizing conditions, plagioclase (pl) and magnetite (mt) are the liquidus phases, followed by low-Ca pyroxene (opx); these three phases coexist over a large temperature (

No abstract

No abstract

Abstract. Attributes of several thousand fractures were collected in three boreholes of 2.2, 3.6, and 3.8 km depth, penetrating the Soultz Hot Dry Rock reservoir (France). The fractures were sampled from cores and from several high-resolution imaging techniques such as borehole televiewer (BHTV), ultrasonic borehole imager (UBI), formation microscanner (FMS), formation microimager (FMI), and azimuthal resistivity imaging (ARI). A comparison was made between the data collected on cores and those provided by different imaging techniques. The comparison clearly establishes that the different wall-images are not as exhaustive as the core data and cannot provide a complete characterization of the fracture network. Discrete fractures thinner than 1 mm are not properly detected. This is also the case for discrete fractures closer than 5 mm, which appear only as single traces. The imaging techniques are, nevertheless, very powerful for characterizing altered fracture clusters. Whatever the technique used, the fracture strikes were correctly sampled with the different systems. This comparison allowed us to calibrate the fracture population data obtained from the imaging system in order to correct for the filtering effect introduced by the technique itself and by the alteration of the rock mass.

. Textures, water content and degassing of silicic andesites from recent plinian and dome-forming eruptions at Mount Pelée volcano (Martinique, Lesser Antilles arc). Journal of Volcanology and Geothermal Research, Elsevier, 2000, 96, pp.191-206. 10.1016/S0377-0273(99) , 1902, and 1929 eruptions, which cover a range of plinian and pelean lithologies) for bulk-rock vesicularities, glass water contents (glass inclusions in phenocrysts and matrix glasses) and microtextures. Water contents of glass inclusions are scattered in the plinian pumices but on average compare with the experimentally-deduced pre-eruptive melt water content (i.e., 5.3-6.3 wt.%), whereas they are much lower in the dominant pelean lithologies (crystalline, poorly vesicular lithics and dome samples). This indicates that the glass inclusions of the pelean products have undergone strong leakage and do not represent pre-eruptive water contents. The water content of the pyroclast matrix glasses are thought to closely represent the residual water content in the melt at the time of fragmentation. Determination of the water contents of both the pre-eruptive melt and matrix glasses allows the estimation of the amount of water exsolved upon syn-eruptive degassing. We find the amount of water exsolved during the eruptive process to be higher in the pelean products than in the plinian ones, typically 90-100 and 65-70% of the initial water content, respectively. The vesicularities calculated from the amount of exsolved water compare with the measured vesicularities for the plinian pumices, consistent with a closed-system, near-equilibrium degassing up to fragmentation. By contrast, the low residual water contents, low groundmass vesicularities and extensive groundmass crystallization of the pelean products are direct evidence of open-system degassing. Microtextural features, including silica-bearing and silica-free voids in the pelean lithologies may represent a two-stage vesiculation.