Inkjet printing for printed electronics is a growing market due to its advantages, including scalability, various usable materials and its digital, pixel based layout design. An important quality factor is the wetting of the ink on the substrate. This article proposes a workflow to evaluate the print quality of specific layouts by means of image analysis. A self-developed image analysis software, which compares a mask with the actual layout, enables a pixel-based analysis of the wetting behavior by the implementation of two parameters called over- and underwetting rate. A comparison of actual and targeted track widths can be performed for the evaluation of different parameters, such as the tested plasma treatment, drop spacing (DS) and substrate temperature. To prove the functionality of the image analyses tool, the print quality of Au structures inkjet printed on cyclic olefin copolymer (COC) substrates was studied experimentally by varying the three previously mentioned parameters. The experimental results showed that the wetting behavior of Au ink deposited on COC substrates influences various line widths differently, leading to higher spreading for smaller line widths. The proposed workflow is suitable for identifying and evaluating multiple tested parameter variations and might be easily adopted for printers for in-process print quality control in industrial manufacturing.

The demolding of plastic parts remains a challenging aspect of injection molding. Despite various experimental studies and known solutions to reduce demolding forces, there is still not a complete understanding of the effects that occur. For this reason, laboratory devices and in-process measurement injection molding tools have been developed to measure demolding forces. However, these tools are mostly used to measure either frictional forces or demolding forces for a specific part geometry. Tools that can be used to measure the adhesion components are still the exception. In this study, a novel injection molding tool based on the principle of measuring adhesion-induced tensile forces is presented. With this tool, the measurement of the demolding force is separated from the actual ejection step of the molded part. The functionality of the tool was verified by molding PET specimens at different mold temperatures, mold insert conditions and geometries. It was demonstrated that once a stable thermal state of the molding tool was achieved, the demolding force could be accurately measured with a comparatively low force variance. A built-in camera was found to be an efficient tool for monitoring the contact surface between the specimen and the mold insert. By comparing the adhesion forces of PET molded on polished uncoated, diamond-like carbon and chromium nitride (CrN) coated mold inserts, it was found that a CrN coating reduced the demolding force by 98.5% and could therefore be an efficient solution to significantly improve demolding by reducing adhesive bond strength under tensile loading.

Hard coatings can be applied onto microstructured molds to influence wear, form filling and demolding behaviors in microinjection molding. As an alternative to this conventional manufacturing procedure, “direct processing” of physical-vapor-deposited (PVD) hard coatings was investigated in this study, by fabricating submicron features directly into the coatings for a subsequent replication via molding. Different diamondlike carbon (DLC) and chromium nitride (CrN) PVD coatings were investigated regarding their suitability for focused ion beam (FIB) milling and microinjection molding using microscope imaging and areal roughness measurements. Each coating type was deposited onto high-gloss polished mold inserts. A specific test pattern containing different submicron features was then FIB-milled into the coatings using varied FIB parameters. The milling results were found to be influenced by the coating morphology and grain microstructure. Using injection–compression molding, the submicron structures were molded onto polycarbonate (PC) and cyclic olefin polymer (COP). The molding results revealed contrasting molding performances for the studied coatings and polymers. For CrN and PC, a sufficient replication fidelity based on AFM measurements was achieved. In contrast, only an insufficient molding result could be obtained for the DLC. No abrasive wear or coating delamination could be found after molding.