A solution-processed diketopyrrolopyrrole (DPP)-based small molecule, namely BDT-DPP, with broad absorption and suitable energy levels has been synthesized. The widely used solvents of chloroform (CF) and o-dichlorobenzene (o-DCB) were used as the spin-coating solvent, respectively, and 1,8-diiodooctane (DIO) was used as additive to fabricate efficient photovoltaic devices with BDT-DPP as the donor material and PC71BM as the acceptor material. Devices fabricated from CF exhibit poor fill factor (FF) of 43%, low short-circuit current density (Jsc) of 6.86 mA/cm(2), and moderate power conversion efficiency (PCE) of 2.4%, due to rapid evaporation of CF, leading to poor morphology of the active layer. When 0.3% DIO was added, the FF and Jsc were improved to 60% and 8.49 mA/cm(2), respectively, because of the better film morphology. Active layer spin-coated from the high-boiling-point solvent of o-DCB shows better phase separation than that from CF, because of the slow drying nature of o-DCB, offering sufficient time for the self-organization of active-layer. Finally, using o-DCB as the parent solvent and 0.7% DIO as the cosolvent, we obtained optimized devices with continuous interpenetrating network films, affording a Jsc of 11.86 mA/cm(2), an open-circuit voltage (Voc) of 0.72 V, an FF of 62%, and a PCE of 5.29%. This PCE is, to the best of our knowledge, the highest efficiency reported to date for devices prepared from the solution-processed DPP-based small molecules.

Phosphate plays an irreplaceable role in the production of fertilizers. However, its finite availability may not be enough to satisfy increasing demands for the fertilizer production worldwide. In this scenario, phosphate recovery can effectively alleviate this problem. Municipal wastewater has received high priority to recover phosphate because its quantity is considerable. Therefore, phosphate recovery from municipal wastewater can bring many benefits such as relieving the burden of increasing production of fertilizers and reduction in occurrence of eutrophication caused by the excessive concentration of phosphate in the released effluent. The chemical processes are the most widely applied in phosphate recovery in municipal wastewater treatment because they are highly stable and efficient, and simple to operate. This paper compares chemical technologies for phosphate recovery from municipal wastewater. As phosphate in the influent is transferred to the liquid and sludge phases, a technical overview of chemical phosphate recovery in both phases is presented with reference to mechanism, efficiency and the main governing parameters. Moreover, an analysis on their applications at plant-scale is also presented. The properties of recovered phosphate and its impact on crops and plants are also assessed with a discussion on the economic feasibility of the technologies.

No abstract

In this paper, a facile strategy to develop graphenebased delivery nanosystems for effective drug loading and sustained drug release was proposed and validated. Specifically, biocompatible naphthalene-terminated PEG (NP) and anticancer drugs (curcumin or doxorubicin (DOX)) were simultaneously integrated onto oxidized graphene (GO), leading to selfassembled, nanosized complexes. It was found that the oxidation degree of GO had a significant impact on the drug-loading efficiency and the structural stability of nanosystems. Interestingly, the nanoassemblies resulted in more effective cellular entry of DOX in comparison with free DOX or DOX-loaded PEGpolyester micelles at equivalent DOX dose, as demonstrated by confocal microscopy studies. Moreover, the nanoassemblies not only exhibited a sustained drug release pattern without an initial burst release, but also significantly improved the stability of formulations which were resistant to drug leaking even in the presence of strong surfactants such as aromatic sodium benzenesulfonate (SBen) and aliphatic sodium dodecylsulfonate (SDS). In addition, the nanoassemblies without DOX loading showed negligible in vitro cytotoxicity, whereas DOX-loaded counterparts led to considerable toxicity against HeLa cells. The DOX-mediated cytotoxicity of the graphene-based formulation was around 20 folds lower than that of free DOX, most likely due to the slow DOX release from complexes. A zebrafish model was established to assess the in vivo safety profile of curcumin-loaded nanosystems. The results showed they were able to excrete from the zebrafish body rapidly and had nearly no influence on the zebrafish upgrowth. Those encouraging results may prompt the advance of graphene-based nanotherapeutics for biomedical applications.