No abstract

Due to the increasing energy crisis and environmental pollution, the development of drive motors for new energy vehicles (NEVs) has become the focus of popular attention. To improve the sine of the air-gap flux density and flux regulation capacity of drive motors, a new hybrid excitation synchronous motor (HESM) has been proposed. The HESM adopts a salient pole rotor with built-in dual-V permanent magnets (PMs), non-arc pole shoes and excitation windings. The fundamental topology, operating principle and analytical model for a magnetic field are presented. In the analytical model, the rotor magnetomotive force (MMF) is derived based on the minimum reluctance principle, and the permeance function considering a non-uniform air-gap is calculated using the magnetic equivalent circuit (MEC) method. Besides, the electromagnetic performance including the air-gap magnetic field and flux regulation capacity is analyzed by the finite element method (FEM). The simulation results of the air-gap magnetic field are consistent with the analytical results. The experiment and simulation results of the performance show that the flux waveform is sinusoidal-shaped and the air-gap flux can be adjusted effectively by changing the excitation current. This study provides design methods and theoretical analysis references for this type of HESM.

Aiming at the problems of large excitation loss and low power generation efficiency of silicon rectifier generators and the unstable output voltage of permanent magnet (PM) generators, a hybrid excitation generator (HEG) with suspended brushless claw pole electrical excitation rotor (EER) and combined magnetic pole PM rotor is proposed in the present work. With only one fractional slot winding stator, the generator adopts PM field as the main magnetic field and electrical excitation field as the auxiliary magnetic field, which not only retains the advantages of high efficiency of PM generators but also effectively reduces excitation consumption. The main structure parameters and the design method were analyzed, and a simulation analysis of no-load magnetic field distribution and flux regulation ability was carried out using finite element software to verify the rationality of the hybrid excitation parallel magnetic circuit design. Moreover, the no-load, load, regulation, and voltage regulation characteristics of the designed generator were tested, and the results show that the designed generator has a wide range of voltage regulation, which can ensure stable output voltage under variable speed and load conditions.

Aiming at the problem of uncontrollable magnetic field of permanent magnet generators, a new hybrid excitation generator (HEG) with parallel magnetic circuit is proposed. The HEG consists of combined permanent magnet rotor (PMR) and brushless electric excitation rotor (EER). The PMR has surface-mounted and embedded magnets. The PMR provides the main air gap field, and the brushless EER is used to adjust the air gap field. The operating principle and electromagnetic design scheme of the proposed generator are given in detail. Besides, the matching with two different types of rotors and the flux regulation characteristics is analyzed by using the finite element method. Finally, the output performance of the proposed generator including no-load and load characteristics and output voltage are tested. The results show that the two different types of rotors can be matched efficiently and operated reliably. The internal magnetic flux is easy to adjust in both directions, and the proposed HEG can output stable voltage in the range of wide speed and load.

In this study, the tangential magnetic field Nd-Fe-B permanent magnet generator is designed and analyzed. In the generator, the adjacent permanent steel is sequentially arranged on the radial groove by the way of same polarity-oriented manner. The optimal design parameters of the generator are obtained by analyzing the influence rule of the generator leakage magnetic flux and leakage coefficient which is affected by the change in rotor pole pairs, permanent steel thickness, magnetic isolation air width, and air-gap length. The mathematical model of the magnetic field is developed and analyzed using the finite element method. Using the finite element method model, the diagrams of magnetic force line distribution, magnetic flux density modulus value, and magnetic flux density vector are obtained, which can be used to verify the validity of the main design parameters. A three-phase half-wave impulse-type controlled rectifier voltage regulator is developed with the function of regulator and rectifier, which proposes a solution to the output voltage instability of the Nd-Fe-B permanent magnet generator in a wide speed and load range.