This article provides a comprehensive review of MXene materials and their energy-related applications.

Grain boundaries in graphene are formed by the joining of islands during the initial growth stage, and these boundaries govern transport properties and related device performance. Although information on the atomic rearrangement at graphene grain boundaries can be obtained using transmission electron microscopy and scanning tunnelling microscopy, large-scale information regarding the distribution of graphene grain boundaries is not easily accessible. Here we use optical microscopy to observe the grain boundaries of large-area graphene (grown on copper foil) directly, without transfer of the graphene. This imaging technique was realized by selectively oxidizing the underlying copper foil through graphene grain boundaries functionalized with O and OH radicals generated by ultraviolet irradiation under moisture-rich ambient conditions: selective diffusion of oxygen radicals through OH-functionalized defect sites was demonstrated by density functional calculations. The sheet resistance of large-area graphene decreased as the graphene grain sizes increased, but no strong correlation with the grain size of the copper was revealed, in contrast to a previous report. Furthermore, the influence of graphene grain boundaries on crack propagation (initialized by bending) and termination was clearly visualized using our technique. Our approach can be used as a simple protocol for evaluating the grain boundaries of other two-dimensional layered structures, such as boron nitride and exfoliated clays.

Coexistence of both edge plane and basal plane in graphite often hinders the understanding of lithium ion diffusion mechanism. In this report, two types of graphene samples were prepared by chemical vapor deposition (CVD): (i) well-defined basal plane graphene grown on Cu foil and (ii) edge plane-enriched graphene layers grown on Ni film. Electrochemical performance of the graphene electrode can be split into two regimes depending on the number of graphene layers: (i) the corrosion-dominant regime and (ii) the lithiation-dominant regime. Li ion diffusion perpendicular to the basal plane of graphene is facilitated by defects, whereas diffusion parallel to the plane is limited by the steric hindrance that originates from aggregated Li ions adsorbed on the abundant defect sites. The critical layer thickness (lc) to effectively prohibit substrate reaction using CVDgrown graphene layers was predicted to be ∼6 layers, independent of defect population. Our density functional theory calculations demonstrate that divacancies and higher order defects have reasonable diffusion barrier heights allowing lithium diffusion through the basal plane but neither monovacancies nor Stone-Wales defect.

Despite recent progress in producing transparent and bendable thin-film transistors using graphene and carbon nanotubes, the development of stretchable devices remains limited either by fragile inorganic oxides or polymer dielectrics with high leakage current. Here we report the fabrication of highly stretchable and transparent field-effect transistors combining graphene/single-walled carbon nanotube (SWCNT) electrodes and a SWCNT-network channel with a geometrically wrinkled inorganic dielectric layer. The wrinkled Al2O3 layer contained effective built-in air gaps with a small gate leakage current of 10(-13) A. The resulting devices exhibited an excellent on/off ratio of ~10(5), a high mobility of ~40 cm(2) V(-1) s(-1) and a low operating voltage of less than 1 V. Importantly, because of the wrinkled dielectric layer, the transistors retained performance under strains as high as 20% without appreciable leakage current increases or physical degradation. No significant performance loss was observed after stretching and releasing the devices for over 1,000 times. The sustainability and performance advances demonstrated here are promising for the adoption of stretchable electronics in a wide variety of future applications.

Two dimensional (2D) materials-based plasmon-free surface-enhanced Raman scattering (SERS) is an emerging field in nondestructive analysis. However, impeded by the low density of state (DOS), an inferior detection sensitivity is frequently encountered due to the low enhancement factor of most 2D materials. Metallic transition-metal dichalcogenides (TMDs) could be ideal plasmon-free SERS substrates because of their abundant DOS near the Fermi level. However, the absence of controllable synthesis of metallic 2D TMDs has hindered their study as SERS substrates. Here, we realize controllable synthesis of ultrathin metallic 2D niobium disulfide (NbS 2 ) (<2.5 nm) with large domain size (>160 μm). We have explored the SERS performance of as-obtained NbS 2 , which shows a detection limit down to 10 −14 mol•L −1 . The enhancement mechanism was studied in depth by density functional theory, which suggested a strong correlation between the SERS performance and DOS near the Fermi level. NbS 2 features the most abundant DOS and strongest binding energy with probe molecules as compared with other 2D materials such as graphene, 1T-phase MoS 2 , and 2H-phase MoS 2 . The large DOS increases the intermolecular charge transfer probability and thus induces prominent Raman enhancement. To extend the results to practical applications, the resulting NbS 2 -based plasmon-free SERS substrates were applied for distinguishing different types of red wines.