No abstract

This research paper on Tac-ELINT SW development method using M&S system describes the validation and verification methods of Tac-ELINT ground operating software development each stages, and the method of improving reusability of software using SBD(Simulation Based Design/Development) concept. In this project, We obtain the EW software SBD technologies and improved Tac-ELINT ground operating software through software crisis mitigation. This method and technology will expect to support a future EW system and any other various weapon software development.

In this paper, we propose a new framework of target classification for a passive coherent location(PCL) radar network. The framework uses radar cross sections(RCSs) obtained from multiple bistatic radars, and is computationally more efficient compared with the conventional method that uses time-varying RCSs obtained from a monostatic radar. Firstly, we construct the training set of the bistatic RCS distribution of each target using the scenario-based method and a PCL radar network with multiple transmitters and a receiver. Next, assuming that a test sequence consists of bistatic RCSs, we classify each target using statistical hypothesis test algorithms, such as Z-test, Wilcoxon test, and sign test. The proposed framework demonstrated better performance than the conventional method, in terms of computational efficiency.

In the direction and location finding field of application, AOA, TDOA and FDOA, etc. are used to improve the performance of geolocation. But, these methods cause some limitations such as the calibrations for phase and amplitude matching and precise time synchronization among receiving channels. In this paper, We suggest a method for generating FDOA using rotating antenna and the geolocation of stationary emitter using two receivers in one platform for minimizing the limitations. We present performance of simulation results and test results of the FDOA geolocation system. The direction finding errors of the system are less than 0.1° rms and the distance errors are less than 3 % compared with the practical distance.

In electronic warfare, the pulse amplitude, one of information of a pulse signal emitted by an enemy, is used for estimating distance from the source and for deinterleaving mixed source signals. An estimate of pulse amplitude is conventionally determined as the maximum magnitude of a Fourier transformed signal within its pulse width which is estimated pre-step in an electronic warfare receiver. However, when frequency modulated signals are received, it is difficult to estimate their pulse amplitudes with this conventional method because the energy of signals is dispersed in frequency domain. In order to overcome this limitation, this paper proposes an enhanced pulse amplitude estimation method which calculates the average power of the received pulse signal in time domain and removes the noise power of the receiver. Simulation results show that even in case the frequency modulated signal is received, the proposed method has the same performance as estimating the pulse amplitude when unmodulated signal is received. In addition, the proposed method is shown to be more robust to an estimation error of pulse width, which affects the estimation performance of pulse amplitude, than the conventional method.