Atomic switches are considered to be building blocks for future non-volatile data storage and internet of things. However, obtaining device structures capable of ultrahigh density data storage, high endurance, and long data retention, and more importantly, understanding the switching mechanisms are still a challenge for atomic switches. Here, we achieved improved resistive switching performance in a bilayer structure containing aluminum oxide, with an oxygen-deficient oxide as the top switching layer and stoichiometric oxide as the bottom switching layer, using atomic layer deposition. This bilayer device showed a high on/off ratio (10) with better endurance (∼2000 cycles) and longer data retention (10 s) than single-oxide layers. In addition, depending on the compliance current, the bilayer device could be operated in four different resistance states. Furthermore, the depth profiles of the hourglass-shaped conductive filament of the bilayer device was observed by conductive atomic force microscopy.
In this study, we demonstrate a high-performance solid polymer electrolyte (SPE) atomic switching device with low SET/RESET voltages (0.25 and -0.5 V, respectively), high on/off-current ratio (10), excellent cyclic endurance (>10), and long retention time (>10 s), where poly-4-vinylphenol (PVP)/poly(melamine-co-formaldehyde) (PMF) is used as an SPE layer. To accomplish these excellent device performance parameters, we reduce the off-current level of the PVP/PMF atomic switching device by improving the electrical insulating property of the PVP/PMF electrolyte through adjustment of the number of cross-linked chains. We then apply a titanium buffer layer to the PVP/PMF switching device for further improvement of bipolar switching behavior and device stability. In addition, we first implement SPE atomic switch-based logic AND and OR circuits with low operating voltages below 2 V by integrating 5 × 5 arrays of PVP/PMF switching devices on the flexible substrate. In particular, this low operating voltage of our logic circuits was much lower than that (>5 V) of the circuits configured by polymer resistive random access memory. This research successfully presents the feasibility of PVP/PMF atomic switches for flexible integrated circuits for next-generation electronic applications.
The next-generation electronic society is dependent on the performance of nonvolatile memory devices, which has been continuously improving. In the last few years, many memory devices have been introduced. However, atomic switches are considered to be a simple and reliable basis for next-generation nonvolatile devices. In general, atomic switch-based resistive switching is controlled by electrochemical metallization. However, excess ion injection from the entire area of the active electrode into the switching layer causes device nonuniformity and degradation of reliability. Here, we propose the fabrication of a high-performance atomic switch based on Cu -Se by inserting lanthanide (Ln) metal buffer layers such as neodymium (Nd), samarium (Sm), dysprosium (Dy), or lutetium (Lu) between the active metal layer and the electrolyte. Current-atomic force microscopy results confirm that Cu ions penetrate through the Ln-buffer layer and form thin conductive filaments inside the switching layer. Compared with the Pt/Cu -Se/AlO/Pt device, the optimized Pt/Cu -Se/Ln/AlO/Pt devices show improvement in the on/off resistance ratio (10-10), retention (10 years/85 °C), endurance (∼10 000 cycles), and uniform resistance state distribution.
The carrier transport and device instability of amorphous oxide semiconductor devices are influenced by defects that are exponentially distributed in energy, because of amorphous phase channels and front/back interfaces with a large number of sub-gap states. Thus, understanding defects and charge trapping in oxide semiconductor transistors is required for being core device element in reliable production lines. In this paper, we present the transient charging effect, the charge trapping mechanism, and the dynamic charge transport of high-mobility bilayer oxide semiconductor transistors. To this end, we exploited microsecond ramps, pulse ID–VG, transient current, and discharge current analysis methods. The mobility enhancement rate of single HfInZnO (HIZO) and bilayer HfInZnO-InZnO (HIZO-IZO) were 173.8 and 28.8%, respectively, in the charge-trapping-free environment. Transient charge trapping can be classified to temperature insensitive fast charging and thermally activated slow charging with two different trap energies. Insignificant fast transient charging of a bilayer-oxide high-mobility thin film transistor(TFT) can be explained by the low density of sub-gap states in the oxide semiconductor. Understanding defects and transient charging in the oxide semiconductor helps to determine the origin of device instability of oxide TFTs, and finally, to solve this problem.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.