No abstract

Palladium doped ZnO was prepared by the sol‐gel and dip‐coating techniques, starting with zinc acetate and palladium chloride as precursors, followed by its hydrolysis in methanol. Acetic acid was incorporated to adjust pH, as well as acetylacetonate and monoehtylamine as stabilizers. The sol was later dipped 3 times in silica substrates. Structural, morphological, and antimicrobial properties of the films were investigated for three palladium contents (1.0, 2.5, and 5 mol %). X‐ray diffraction (XRD) showed that the films have a hexagonal structure after been annealed at 500°C. X‐ray photoelectron Spectroscope (XPS) showed that Pd is present in its oxidized form. Atomic force microscopy (AFM) from films showed a crack free and smooth surface (Ra= 18 nm), composed of cross‐linked particles. The synthesized films presented antibacterial activity against Escherichia coli and Pseudomona aeruginosa. It was observed that the higher Pd content (5 mol %) presents the higher antimicrobial ratio, 64.07%, for the E. coli, whereas for the P. aeruginosa, the lower Pd content (1 mol %), shows the higher antimicrobial ratio, 76.43%.

In this work, the influence of carbon nanotubes (CNTs) content on the mechanical and electrical properties of four series of polymeric matrix were made and their cytotoxicity on cells was evaluated to consider their use as a possible artificial muscle. For that, polymer composite yarns were electrospun using polymeric solutions at 10 wt.%. of poly(styrene-co-acrylonitrile) P(S:AN) and P(S:AN-acrylic acid) P(S:AN-AA) at several monomeric concentrations, namely 0:100, 20:80, 40:60, 50:50 (wt.%:wt.%), and 1 wt.% of AA. Carbon nanotubes (CNTs) were added to the polymeric solutions at two concentrations, 0.5 and 1.0 wt.%. PMCs yarns were collected using a blade collector. Mechanical and electrical properties of polymeric yarns indicated a dependence of CNTs content into yarns. Three areas could be found in fibers: CNTs bundles zones, distributed and aligned CNTs zones, and polymer-only zones. PMCs yarns with 0.5 wt.% CNTs concentration were found with a homogenous nanotube dispersion and axial alignment in polymeric yarn, ensuring load transfer on the polymeric matrix to CNTs, increasing the elastic modulus up to 27 MPa, and a maximum electrical current of 1.8 mA due to a good polymer–nanotube interaction.

A choline chloride/urea natural deep eutectic solvent (ChCl NADES) was prepared via a green chemistry method and used to leach Zn and Mn oxides from conventional Zn–C scrap batteries. FTIR and 1H NMR spectroscopy were used to characterize the NADES. The leaching kinetics of the Zn and Mn oxides was monitored at isothermal conditions (80, 100, 125, and 150 °C) and at two solid/NADES ratios: 3.3 and 10 g dm−3. It was possible to dissolve Zn and Mn oxides under all of tested conditions, reaching more than a 95% recovery for both metals at 150 °C after 90 min, whereas, at 25 °C, it was possible to leach up to 90% of the Zn and 30% of the Mn after 4320 min (72 h). Furthermore, the leaching kinetics was controlled by the boundary layer, coincident with a shrinking core model. According to the Arrhenius plot, the activation energy for Zn ranges from 49.13 to 52.21 kJ mol−1, and that for Mn ranges from 46.97 to 66.77 kJ mol−1.