Objective:The aim of this study was to investigate the incidence of carious lesions, the amount of salivary flow rate and pH value in patients with asthma and chronic obstructive pulmonary diseases (COPD), using inhalation therapy. The obtained results were compared with the results of adult healthy subjects, forming a control group.Material and Methods:The study included 80 participants aging between 18 and 65 years. The experimental group (EG) was comprised of 40 participants, previously diagnosed with asthma or COPD undergoing inhalation therapy for more than five years. The control group (CG), comprised of 40 participants, mirrored the same age and gender status of the EG. Dental status was determined by decayed, missing, and filled teeth (DMFT index). Quantity and pH value of saliva were determined in the laboratory.Results:In the EG, the mean value of the salivary flow rate and pH value were statistically significantly lower than in the CG (p<0.001). Patients in the EG had a higher value of DMFT index when compared with the CG, although the difference was not statistically significant (p=0.199). Mean number of decayed teeth, as well as missing teeth, in the EG was statistically significantly higher than in the CG (p<0.001). Mean number of filled teeth in the EG was statistically significantly lower than in the CG (p<0.001).Conclusion:It was found that patients undergoing inhalation therapy face increasing risk of dental caries due to the lower salivary flow rate and pH value along with the inhalation therapy. They should receive intensive preventive care, including oral hygiene instruction and dietary advice.

Dental erosions could be considered to be the extraesophageal manifestation ofgastroesophageal reflux.

Dentin hypersensitivity is a problem that bothers many patients. Many conditions share the symptoms of tooth sensitivity so differential diagnosis is essential for suitable treatment or preventive measures.

Background/Aim. Excessive consumption of acidic dietary substances, such as carbonated beverages, increased the chances of dental erosion. The aim of this study was to determine influence of carbonated beverages on enamel and dentin, during different intervals. Methods. Sixty samples were obtained from fifteen impacted third molars. Tooth crown was divided into four parts. One part was a control sample, immersed in destilled water and other three parts were the experimental samples, stored in the following tested beverages: carbonated water, Coca-Cola and Schweppes Bitter Lemon. For each beverage, pH was measured before immersion of the samples. The first group of twenty samples were analysed and photographed, using a Scanning Electron Microscope (SEM), after 60 minutes, the second group after 24 hours and the third group after 7 days of exposure to drinks. The enamel was analysed on the outer surface of the cusps and longitudinal section. Dentin was analysed on longitudinal section. An individually adopted scale was used for determination of the degree of erosive changes of these dental tissues. The data were analysed using the analysis of varance (ANOVA). Results. The pH levels of the tested beverages was bellow the critical pH for enamel demineralisation. The SEM images showed different intensity of erosive changes caused by the tested beverages. The analysis by ANOVA revealed a significant difference between all groups of the treated samples, after 60 minutes of exposure to beverages. The highest values of erosive changes showed the samples that were immersed in Schweppes Bitter Lemon. The analysis of the samples after 24 hours and 7 days showed that the samples immersed in Coca-Cola and Schweppes Bitter Lemon can be classified as one group that was statistically significantly different compared with the control samples and samples immersed in carbonated water. Conclusion. Prolonged exposure of dental tissue to carbonated beverages cause erosive changes and a loss of surface profile. Z, et al. Vojnosanit Pregl 2019; 76(4): 422-430. topljeni u Schweppes Bitter Lemon. Analiza uzoraka nakon 24 sata i sedam dana izloženosti delovanju napitaka pokazala je da uzorci potopljeni u Coca-Cola-u i Schweppes Bitter Lemon mogu biti svrstani u jednu grupu koja je statistički značajno različita u odnosu na kontrolne uzorke i uzorke potopljene u gaziranu vodu. Zaključak. Povećano izlaganje zubnih tkiva delovanju gaziranih napitaka uzrokuje erozivne promene i gubitak površinske strukture. Apstrakt Panić

This study evaluated microleakage in vitro of self-etch and multi-step, total-etch adhesive systems. Ninety extracted non-carious human molars were randomly assigned to nine groups (n=10) and restored with nine different composite systems: Gluma CPS/Charisma, Syntac Sprint/Tetric Ceram, 3M Single Bond/Silux, Admira Bond/Admira, Optibond Solo Plus/Herculite, Trendy Bond/Saremco, Excite/Tetric Ceram, Syntac Sprint/Compoglass and Promt-L-Pop/Silux. Cavities (2 mm diameter/2 mm deep) were prepared on the facial and lingual surfaces of each tooth previously abraded with a silicon-carbide abrasion discs to produce two level dentin surfaces with whole margins in dentin. Each group of composite systems was treated following the manufacturer's instructions. After they were finished and polished, the specimens were subjected to 100 thermal cycles in baths of 4 degrees +/- 2 degrees C and 58 degrees +/- 2 degrees C with 60 seconds of dwell time for each bath. After the thermocycling, the specimens were sealed with acid-resistant varnish, leaving a 1-mm window around the cervical margin interface, and immersed in 1% methylene blue buffered solution for 4 hours. Then the specimens were sectioned longitudinally in half and evaluated under stereomicroscopy at 30 times magnification, using inserted millimeter measurer. Each specimen was measured for dye penetration, thickness of composite filling and distance from the bottom ofcavity to the pulp chamber. The data were analyzed using Kruskal-Wallis Analysis of Variance (ANOVA) and Pearson t- test. Syntac Sprint/Tetric Ceram, 3M Single Bond/Silux, Admira Bond/Admira, Optibond Solo Plus/Herculite and Gluma CPS/Charisma showed the least microleakage at the occlusal part of the cavity. There was no significant difference of microleakage at gingival part of cavity for all tested composite systems and the best sealing ability showed 3M Single Bond/Silux. Self-etch and multi-step, total-etch adhesive systems showed more or less similar microleakage "in vitro" conditions and marginal sealing ability of all tested composite systems was significantly lower at gingival margins of cavities.