In the last ten to fifteen years there has been much research in using amorphous and polycrystalline semiconductors as x-ray photoconductors in various x-ray image sensor applications, most notably in flat panel x-ray imagers (FPXIs). We first outline the essential requirements for an ideal large area photoconductor for use in a FPXI, and discuss how some of the current amorphous and polycrystalline semiconductors fulfill these requirements. At present, only stabilized amorphous selenium (doped and alloyed a-Se) has been commercialized, and FPXIs based on a-Se are particularly suitable for mammography, operating at the ideal limit of high detective quantum efficiency (DQE). Further, these FPXIs can also be used in real-time, and have already been used in such applications as tomosynthesis. We discuss some of the important attributes of amorphous and polycrystalline x-ray photoconductors such as their large area deposition ability, charge collection efficiency, x-ray sensitivity, DQE, modulation transfer function (MTF) and the importance of the dark current. We show the importance of charge trapping in limiting not only the sensitivity but also the resolution of these detectors. Limitations on the maximum acceptable dark current and the corresponding charge collection efficiency jointly impose a practical constraint that many photoconductors fail to satisfy. We discuss the case of a-Se in which the dark current was brought down by three orders of magnitude by the use of special blocking layers to satisfy the dark current constraint. There are also a number of polycrystalline photoconductors, HgI2 and PbO being good examples, that show potential for commercialization in the same way that multilayer stabilized a-Se x-ray photoconductors were developed for commercial applications. We highlight the unique nature of avalanche multiplication in a-Se and how it has led to the development of the commercial HARP video-tube. An all solid state version of the HARP has been recently demonstrated with excellent avalanche gains; the latter is expected to lead to a number of novel imaging device applications that would be quantum noise limited. While passive pixel sensors use one TFT (thin film transistor) as a switch at the pixel, active pixel sensors (APSs) have two or more transistors and provide gain at the pixel level. The advantages of APS based x-ray imagers are also discussed with examples.

No abstract

A theoretical model for describing the bias-dependent transient behavior of dark current in multilayer (n-i-p) amorphous selenium (a-Se) detectors has been developed. The transient dark currents in these detectors are measured and are compared to the proposed dark current model. It has been found that the dark current is mainly controlled by Schottky emission of holes from the metal/a-Se contact. The initial and steady state dark currents are mainly controlled by the barrier height and the trap centers in the n layer, respectively.

No abstract

Articles you may be interested inGrowth kinetics and mass transport mechanisms of GaN columns by selective area metal organic vapor phase epitaxy Heteroepitaxy of InP on Si(001) by selective-area metal organic vapor-phase epitaxy in sub-50nm width trenches: The role of the nucleation layer and the recess engineering Selective area growth of InP on lithography-free, nanopatterned GaAs(001) by metalorganic chemical vapor deposition J. Vac. Sci. Technol. B 32, 011210 (2014); 10.1116/1.4855035 Mask pattern interference in AlGaInAs selective area metal-organic vapor-phase epitaxy: Experimental and modeling analysisSelective area epitaxy of InP on masked ͑100͒ InP substrates is studied. InP layers are deposited between pairs of SiO 2 stripes using low-pressure metalorganic chemical vapor deposition. Layer thickness is investigated by surface profiling and scanning electron microscopy. For growth between oxide stripes, the growth velocity is enhanced by lateral diffusion of growth species from the masked region to the exposed region. Two transport mechanisms are known to exist: vapor phase diffusion and surface migration. However, most existing quantitative models focus only on the former. A new computational model, based on the diffusion equation with time dependent boundary conditions, is presented which describes the growth enhancement component due to surface migration. The role played by surface migration is shown to depend on nominal film thickness. The model correctly predicts a super growth enhanced region adjacent to the oxide. Previous quantitative models have not successfully described this aspect of growth near the oxide film.