In this two-part article, the weldabilities of AA 1100 aluminum and AISI 409 stainless steel by the pulsed Nd:YAG laser welding process have been examined experimentally and compared. The effects of laser pulse time and power density on laser spot weld characteristics, such as weld diameter, penetration, melt area, melting ratio, porosity, and surface cratering, have been studied and explained qualitatively in relation to material-dependent variables such as absorptivity and thermophysical properties. The weldability of AISI 409 stainless steel was reported in Part I of this article. In the present article, the weldability of AA 1100 aluminum is reported and compared to that of AISI 409 stainless steel. Weld pool shapes in aluminum were found to be influenced by the mean power density of the laser beam and the laser pulse time. Both conduction-mode and keyhole-mode welding were observed in aluminum. Unlike stainless steel, however, drilling was not observed. Conduction-mode welds were produced in aluminum at power densities ranging from 3.2 to 10 GW/m 2 . The power density required for melting aluminum was approximately 4.5 times greater than stainless steel. The initial transient in weld pool development in aluminum occurred within 2 ms, and the aspect ratios (depth/width) of the steady-state conduction-mode weld pools were approximately 0.2. These values are about half those observed in stainless steel. The transition from conduction-to keyhole-mode welding occurred in aluminum at a power density of about 10 GW/m 2 , compared to about 4 GW/m 2 for stainless steel. Weld defects such as porosity and cratering were observed in both aluminum and stainless steel spot welds. In both materials, there was an increased propensity for large occluded vapor pores near the root of keyhole-mode welds with increasing power density. In aluminum, pores were observed close to the fusion boundary. These could be eliminated by surface milling and vacuum annealing the specimens, suggesting that such pores were due to hydrogen. Finally, excellent agreement was obtained between experimental data from both alloys and an existing analytical model for conduction-mode laser spot welding. Two nondimensional parameters, the Fourier number and a nondimensional incident heat flux parameter, were derived and shown to completely characterize weld pool development in conduction-mode welds made in both materials.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.