No abstract

The BLT equation has been used as a useful technique for analyzing coupling effects inside the huge devices in the frequency domain. To expand its applications into further complicated systems, it has been applied with numerical solutions. In this paper, the combination techniques are used to investigate the coupling effects in a waveguide structure.Consequently, it shows excellent agreements with the results calculated using much more time consuming full-wave analysis.

A non-lethal weapon is a device that can subdue targets without causing death or mortal wounds. A high-intensity flash generator can negate electro-optical sensors and cause temporal flash blindness with a high intensity of light. In this study, we derive the design parameters of an explosive-driven high-intensity flash generator that uses the interaction of plasma caused by the detonation of explosives with surrounding inert gas. To determine the design parameters of the flash generator, we analyze test results measured using optical sensors. The experimental results show that the light intensity of xenon gas is about four times higher than that of air. In addition, the intensity increases with the weight of the explosive, and the inert gas cross-sectional area encountered a shock wave in the airframe. The light intensity caused by a double-initiation generator is about two times higher than that of the single-initiation generator.

A design procedure for a TEM-wire fed parabolic antenna is given for impulse radiation, which is suitable for low cost fabrication. A simple wire-type TEM horn and a parabolic reflector are used to achieve ultra-wide bandwidth and high directivity at the same time. Equations for parametric curves of a TEM-wire horn are presented and are used to investigate the relation among their shapes, bandwidth, and directivity. It is also found that wire separation near the focal point limits the high frequency directivity.