The article presents a research in the field of morphing wings (adaptive wing geometry) developed over a prototype of micro-unmanned air vehicle based on smart materials technology. This morphing wing will optimize the aircraft performance features. Modifying the curvature of the wing, the micro-unmanned air vehicles will adjust its performance in an optimum mode to cruise flight condition as well as in the phases of takeoff and landing. The installation of mechanical elements for control surfaces in small size aircraft means, on some occasions, an extra complexity. In addition, it takes into account an increase in aircraft weight. In this research, the adaptive wing geometry is based on macro-fiber composites, so that its position on the inner surfaces of the wing allows the appropriate modification of the curvature, adapting them to the flight profile. This research will present the conceptual design of the vehicle, computational calculations, experimental results of the wind tunnel testing, validations using non-intrusive techniques (particle image velocimetry) and a theoretical–experimental analysis of the macro-fiber composite effects over the wing. An Arduino board will perform the control parameters of the macro-fiber composite deformation. With these analytical, computational, and experimental results, the most relevant conclusions are presented.

This research shows an experimental study and analysis on microbubbles formation, through the use of chemically modified optical fiber tips. Microbubbles are formed in highly absorbent liquid using a continuous wave laser at 980 nm, with conventional powers. This report is considered, as the first study and dynamic analysis for microbubble formation in solution with these particular types of tips. Fiber tips are modified by the chemical wear method, using hydrofluoric acid, while, microbubbles are generated with the help of the deposition or adhesion of nanostructures on the modified tips. We have used carbon nanotubes dissolved in ethanol as nanostructures. We present an analysis of the results considering: the growth curves of the microbubbles, the largest radii, the lifetime and the growth rate. Finally, we discuss the important features of results, suggesting a possible way to control the size and number of microbubbles. Furthermore, the results of our research could be useful to improve the proposals of earlier applications or to propose new ones. The results shown can be useful for new applications or to improve proposals.