Graphene films grown on Cu foils have been fluorinated with xenon difluoride (XeF(2)) gas on one or both sides. When exposed on one side the F coverage saturates at 25% (C(4)F), which is optically transparent, over 6 orders of magnitude more resistive than graphene, and readily patterned. Density functional calculations for varying coverages indicate that a C(4)F configuration is lowest in energy and that the calculated band gap increases with increasing coverage, becoming 2.93 eV for one C(4)F configuration. During defluorination, we find hydrazine treatment effectively removes fluorine while retaining graphene's carbon skeleton. The same films may be fluorinated on both sides by transferring graphene to a silicon-on-insulator substrate enabling XeF(2) gas to etch the Si underlayer and fluorinate the backside of the graphene film to form perfluorographane (CF) for which calculated the band gap is 3.07 eV. Our results indicate single-side fluorination provides the necessary electronic and optical changes to be practical for graphene device applications.

We report the first observation of linear magnetoresistance (LMR) in multilayer epitaxial graphene grown on SiC. We show that multilayer epitaxial graphene exhibits large LMR from 2.2 K up to room temperature and that it can be best explained by a purely quantum mechanical model. We attribute the observation of LMR to inhomogeneities in the epitaxially grown graphene film. The large magnitude of the LMR suggests potential for novel applications in areas such as high-density data storage and magnetic sensors and actuators.

No abstract

Monolayer WS2 offers great promise for use in optical devices due to its direct bandgap and high photoluminescence intensity. While fundamental investigations can be performed on exfoliated material, large-area and high quality materials are essential for implementation of technological applications. In this work, we synthesize monolayer WS2 under various controlled conditions and characterize the films using photoluminescence, Raman and x-ray photoelectron spectroscopies. We demonstrate that the introduction of hydrogen to the argon carrier gas dramatically improves the optical quality and increases the growth area of WS2, resulting in films exhibiting mm2 coverage. The addition of hydrogen more effectively reduces the WO3 precursor and protects against oxidative etching of the synthesized monolayers. The stoichiometric WS2 monolayers synthesized using Ar + H2 carrier gas exhibit superior optical characteristics, with photoluminescence emission full width half maximum (FWHM) values below 40 meV and emission intensities nearly an order of magnitude higher than films synthesized in a pure Ar environment.

Epitaxial graphene films were grown in vacuo by silicon sublimation from the (0001) and (0001) faces of 4H-and 6H-SiC. Hall effect mobilities and sheet carrier densities of the films were measured at 300 K and 77 K and the data depended on the growth face. About 40% of the samples exhibited holes as the dominant carrier, independent of face. Generally, mobilities increased with decreasing carrier density, independent of carrier type and substrate polytype. The contributions of scattering mechanisms to the conductivities of the films are discussed. The results suggest that for near-intrinsic carrier densities at 300 K epitaxial graphene mobilities will be ~150,000 cm 2 V -1 s -1 on the (0001) face and ~5,800 cm 2 V -1 s -1 on the (0001) face.