This paper reports about the non-destructive evaluation of surfaces after severe shot peening via the Barkhausen noise technique. Residuals stresses and the corresponding Almen intensity, as well as microstructure alterations, are correlated with the Barkhausen noise signal and its extracted features. It was found that residual stresses as well as the Barkhausen noise exhibit a valuable anisotropy. For this reason, the relationship between the Barkhausen noise and stress state is more complicated. On the other hand, the near-the-surface layer exhibits a remarkable deformation induced softening, expressed in terms of the microhardness and the corresponding crystalline size. Such an effect explains the progressive increase of the Barkhausen noise emission along with the shot-peening time. Therefore, the Barkhausen noise can be considered as a promising technique capable of distinguishing between the variable regimes of severe shoot peening.

No abstract

The nil-strength temperature, zero strength temperature and solidus temperature are significant parameters with respect to the processes of melting, casting and welding steels. With the use of physical tests performed on the universal plastometer Gleeble 3800 and calculations in the IDS software, the nil-strength temperatures, zero strength temperatures and solidus temperatures of nine non-alloy carbon steels have been determined. Apart from that, solidus temperatures were also calculated by the use of four equations expressing a mathematical relation of this temperature to the chemical composition of the investigated steels. The nil-strength and zero strength temperatures and the solidus temperatures decreased with increasing carbon content in the investigated steels. Much higher content of sulfur in free-cutting steel resulted in a decrease of all the temperatures investigated. The zero strength temperatures determined by calculation in the IDS software during solidification were approximately 43–85 °C higher than the nil-strength temperatures determined experimentally during heating of the investigated steels. The linear dependence of experimentally measured nil-strength temperature on the calculated zero strength temperature for the investigated steels was determined. Based on regression analyses, there were determined mathematical relations which described with high accuracy a linear dependence of the nil-strength and zero strength temperatures on the solidus temperature of the investigated steels.

The main topic of this paper is a static analysis of transmission tower beam structure fixed to the earth. It contains facts necessary for a need to create and apply tower beam structures. Beam elements were used to design a model and a static analysis was performed in finite element program Ansys Workbench. Three types of analyses were applied. The modal analysis was applied to verify the model compatibility. The static analysis was applied to find maximal deformations and the bending moment caused by overhead conductors and self-weight. Eigenvalue buckling was applied to state a loss of stability. Finally, stability and suitability of the whole construction was considered.

This article is focused on an analysis of factors negatively affecting the tube production process of tubes made from austenitic stainless steel with a very small diameter of ϕ 0.34 mm. The analysis was concentrated on factors that affect the drawing process stability of the seam tubes where the desired final dimensions—a diameter of ϕ 0.34 mm and a wall thickness of 0.057 mm—are limiting factors. Seam tubes made from steel 1.4306 and 1.4301, from producers KT and EW with a longitudinal weld line made by tungsten inert gas (TIG) welding, were used as blanks for constituent drawing operations. It is desirable to provide sufficient inert gas flow and cooling during the formation of a weld joint in a protective atmosphere chamber. A significant temperature gradient prevents the formation of undesirable Cr23C6 carbides in the heat-affected zone (HAZ) which negatively affects the plasticity and formability of the steel and is the cause of technological fractures.