Perylene-3,4:9,10-bis(dicarboximide) (PDI) and its derivatives are robust organic dyes that strongly absorb visible light and display a strong tendency to self-assemble into ordered aggregates, having significant interest as photoactive materials in a wide variety of organic electronics. To better understand the nature of the electronics states produced by photoexcitation of such aggregates, the photophysics of a series of covalent, cofacially oriented, pi-stacked dimers and trimers of PDI and 1,7-bis(3',5'-di-t-butylphenoxy)perylene-3,4:9,10-bis(dicarboximide) (PPDI) were characterized using both time-resolved absorption and fluorescence spectroscopy. The covalent linkage between the chromophores was accomplished using 9,9-dimethylxanthene spacers. Placing n-octyl groups on the imide nitrogen atoms at the end of the PDI chromophores not attached to the xanthene spacer results in PDI dimers having near optimal pi-stacking, leading to formation of a low-energy excimer-like state, while substituting the more sterically demanding 12-tricosanyl group on the imides causes deviations from the optimum that result in slower formation of an excimer-like excited state having somewhat higher energy. By comparison, PPDI dimers having terminal n-octyl imide groups have two isomers, whose photophysical properties depend on the ability of the phenoxy groups at the 1,7-positions to modify the pi stacking of the PPDI molecules. In general, disruption of optimal pi-stacking by steric interactions of the phenoxy side groups results in excimer-like states that are higher in energy. The corresponding lowest excited singlet states of the PDI and PPDI trimers are dimer-like in nature and suggest that structural distortions that accompany formation of the trimers are sufficient to confine the electronic interaction on two chromophores within these systems. This further suggests that it may be useful to build into oligomeric PDI and PPDI systems some degree of flexibility that allows the structural relaxations necessary to promote electronic interactions between multiple chromophores.

A robust and porous Zr metal-organic framework (MOF) based on a BINAP-derived dicarboxylate linker, BINAP-MOF, was synthesized and post-synthetically metalated with Ru and Rh complexes to afford highly enantioselective catalysts for important organic transformations. The Rh-functionalized MOF is not only highly enantioselective (up to >99% ee) but also 3 times as active as the homogeneous control. XAFS studies revealed that the Ru-functionalized MOF contains Ru-BINAP precatalysts with the same coordination environment as the homogeneous Ru complex. The post-synthetically metalated BINAP-MOFs provide a versatile family of single-site solid catalysts for catalyzing a broad scope of asymmetric organic transformations, including addition of aryl and alkyl groups to α,β-unsaturated ketones and hydrogenation of substituted alkene and carbonyl compounds.

The metal-to-ligand-charge-transfer (MLCT) excited state of Cu(I) diimine complexes is known to undergo structural reorganization, transforming from a pseudotetrahedral D(2d) symmetry in the ground state to a flattened D(2) symmetry in the MLCT state, which allows ligation with a solvent molecule, forming an exciplex intermediate. Therefore, the structural factors that influence the coordination geometry change and the solvent accessibility to the copper center in the MLCT state could be used to control the excited state properties. In this study, we investigated an extreme case of the steric hindrance caused by attaching bulky tert-butyl groups in bis(2,9-di-tert-butyl-1,10-phenanthroline)copper(I), [Cu(I)(dtbp)(2)](+). The two bulky tert-butyl groups on the dtbp ligand lock the MLCT state into the pseudotetrahedral coordination geometry and completely block the solvent access to the copper center in the MLCT state of [Cu(I)(dtbp)(2)](+). Using ultrafast transient absorption spectroscopy and time-resolved emission spectroscopy, we investigated the MLCT state property changes due to the steric hindrance and demonstrated that [Cu(I)(dtbp)(2)](+) exhibited a long-lived emission but no subpicosecond component that was previously assigned as the flattening of the pseudotetrahedral coordination geometry. This suggests the retention of its pseudotetrahedral D(2d) symmetry and the blockage of the solvent accessibility. We made a comparison between the excited state dynamics of [Cu(I)(dtbp)(2)](+) with its mono-tert-butyl counterpart, bis(2-tert-butyl-1,10-phenanthroline)copper(I) [Cu(I)(tbp)(2)](+). The subpicosecond component assigned to the flattening of the D(2d) coordination geometry in the MLCT excited state was again present in the latter because the absence of a tert-butyl on the phenanthroline allows flattening to the pseudotetrahedral coordination geometry. Unlike the [Cu(I)(dtbp)(2)](+), [Cu(I)(tbp)(2)](+) exhibited no detectable emission at room temperature in solution. These results provide new insights into the manipulation of various excited state properties in Cu diimine complexes by certain key structural factors, enabling optimization of these systems for solar energy conversion applications.

The excited-state structure of a dinuclear platinum(II) complex with tert-butyl substituted pyrazolate bridging units, [Pt(ppy)(μ-(t)Bu(2)pz)](2) (ppy = 2-phenylpyridine; (t)Bu(2)pz = 3,5-di-tert-butylpyrazolate) is studied by X-ray transient absorption (XTA) spectroscopy to reveal the transient electronic and nuclear geometry. DFT calculations predict that the lowest energy triplet excited state, assigned to a metal-metal-to-ligand charge transfer (MMLCT) transition, has a contraction in the Pt-Pt distance. The Pt-Pt bond length and other structural parameters extracted from fitting the experimental XTA difference spectra from full multiple scattering (FMS) and multidimensional interpolation calculations indicates a metal-metal distance decrease by approximately 0.2 Å in the triplet excited state. The advantages and challenges of this approach in resolving dynamic transient structures of nonbonding or weak-bonding dinuclear metal complexes in solution are discussed.