A reluctance lead screw (RLS) is proposed in this paper which consists of a rotor and a translator, forming a magnetic device that is able to transfer low-speed linear motion into high-speed rotational motion. Permanent magnets (PMs) are only installed in the rotor, making it more suitable for long-stroke applications. The design aspects are assessed by finite element analysis (FEA) and the performance is evaluated. In addition, the thrust force per magnet volume is presented for evaluating the utilization rate of the PMs. The simulation results show that RLS has an advantage in terms of the PM utilization rate. A new method for realizing spiral magnets has also been developed which can not only reduce the manufacturing difficulties, but also ease the installation work. Finally, based on the simulations and analyses, two RLS prototypes designed for wave energy converters (WECs) are presented to show the potential applications of this novel topology.

An improved anisotropic vector Preisach model is proposed in this paper to describe the hysteresis properties of nonoriented (NO) electrical steel sheet (ESS) under 50 Hz rotating magnetic fields. The proposed model consists of three components, static hysteresis component, eddy current component, and excess component, which is based on the iron loss separation theory. The static hysteresis component is constructed by the static vector Preisach model. The proposed model is identified by the measured hysteresis properties under 1 Hz and 50 Hz magnetic fields. Finally, the experimental results prove the effectiveness of the proposed anisotropic vector hysteresis model.

This study introduces a new structure of the magnetic lead screw (MLS) intended for wave energy conversion (WEC) applications. One of the key challenges in the application of MLS technology for wave energy lies in the manufacturing of its complicated ideal helix. Structural simplification and processing technology are quite essential in promoting the development of the magnet screw. This study proposes a new method for shaping the desired ideal helix in a simple way with parallelly magnetised magnets. This simple structure reduces manufacturing complexity while maintaining good force density. The magnets with parallel magnetisation are also easier and cheaper to manufacture than the magnets with radial magnetisation. A prototype is manufactured and tested in the laboratory. In addition, the electromagnetic performance of the new structure is evaluated as compared with the magnet screw with ideal helix using the three‐dimensional finite element analysis, verifying the advantages of the proposed structure.

No abstract

No abstract