Crystal facet engineering of semiconductors has become an important strategy for fine-tuning the physicochemical properties and thus optimizing the reactivity and selectivity of photocatalysts. In this review, we present the basic strategies for crystal facet engineering of photocatalysts and describe the recent advances in synthesizing faceted photocatalysts, in particular TiO(2) crystals. The unique properties of faceted photocatalysts are discussed in relation to anisotropic corrosion, interaction dependence of adsorbates, photocatalytic selectivity, photo-reduction and oxidation sites, and photocatalytic reaction order. Ideas for future research on crystal facet engineering for improving the performance of photocatalysts are also proposed.

The efficient use of solar energy has received wide interest due to increasing energy and environmental concerns. A potential means in chemistry is sunlight-driven catalytic reactions. We report here on the direct harvesting of visible-to-near-infrared light for chemical reactions by use of plasmonic Au-Pd nanostructures. The intimate integration of plasmonic Au nanorods with catalytic Pd nanoparticles through seeded growth enabled efficient light harvesting for catalytic reactions on the nanostructures. Upon plasmon excitation, catalytic reactions were induced and accelerated through both plasmonic photocatalysis and photothermal conversion. Under the illumination of an 809 nm laser at 1.68 W, the yield of the Suzuki coupling reaction was ~2 times that obtained when the reaction was thermally heated to the same temperature. Moreover, the yield was also ~2 times that obtained from Au-TiOx-Pd nanostructures under the same laser illumination, where a 25-nm-thick TiOx shell was introduced to prevent the photocatalysis process. This is a more direct comparison between the effect of joint plasmonic photocatalysis and photothermal conversion with that of sole photothermal conversion. The contribution of plasmonic photocatalysis became larger when the laser illumination was at the plasmon resonance wavelength. It increased when the power of the incident laser at the plasmon resonance was raised. Differently sized Au-Pd nanostructures were further designed and mixed together to make the mixture light-responsive over the visible to near-infrared region. In the presence of the mixture, the reactions were completed within 2 h under sunlight, while almost no reactions occurred in the dark.

A surfactant-templated approach was used to synthesize phosphated mesoporous titanium dioxide by incorporating phosphorus from phosphoric acid directly into the framework of TiO2. The resulting materials were characterized by XRD, nitrogen adsorption, TEM, XPS analysis, UV−vis spectroscopy, FT-IR spectroscopy, and isoelectric point measurements. The surface area of phosphated mesoporous TiO2 exceeded 300 m2/g after calcination at 400 °C. It was found that the incorporation of phosphorus could stabilize the TiO2 framework and increase the surface area significantly. This stabilization is attributed to two reasons:  the more complete condensation of surface Ti−OH in the as-prepared sample and the inhibition of grain growth of the embedded anatase TiO2 by the interspersed amorphous titanium phosphate matrix during thermal treatment. Both pure and phosphated mesoporous TiO2 show significant activities on the oxidation of n-pentane. The higher photocatalytic activity of phosphated mesoporous TiO2 can be explained by the extended band gap energy, large surface area, and the existence of Ti ions in a tetrahedral coordination.

Free‐standing α‐Fe2O3 nanorings are synthesized in solution through a rapid microwave‐assisted hydrothermal process. The ringlike structure is a new member in the family of iron oxide nanostructures. The sensors made of the α‐Fe2O3 nanorings exhibit high sensitivity not only for bio‐sensing of hydrogen peroxide in a physiological solution but also for gas‐sensing of alcohol vapor at room temperature.