We demonstrate an atom-based amplitude-modulation (AM) receiver for digital communication with a weak continuous frequency carrier using a Rydberg AC Stark effect in a vapor cell and achieve the operating carrier frequency continuously from 0.1 GHz to 5 GHz at a single Rydberg state. A strong local oscillator (LO) field E LO acts as a gain to shift the Rydberg level to a high sensitivity region, and a weak carrier field E Carr keeps the same frequency with the LO field. The digital baseband signals are encoded onto the E Carr using the amplitude modulation technique with the different modulation frequency. The response of Rydberg atom to the baseband signal is probed via a Rydberg electromagnetically induced transparency (EIT). The measured instantaneous bandwidth of the system is about 230 kHz. To demonstrate the performance of our system for an actual communication, we consider a color image as an example, the received image displays that the bit error rate (BER) is less than 5% when the maximum data transfer rate is about 238 kbps. Meanwhile, our system shows the weak carrier field of E Carr ≥ 13.52 μV/cm can be used for the practical communication with BER less than 5%. Our works break the limitation that EIT-AT based atomic receivers only operate at the near resonant frequencies of the Rydberg transitions, making this emerging of quantum technology close to the practical application with high sensitivity and broad bandwidth.

We demonstrate a continuously tunable electric field measurement based on the far off-resonant AC stark effect in a Rydberg atomic vapor cell. In this configuration, a strong far off-resonant field, denoted as a local oscillator (LO) field, acts as a gain to shift the Rydberg level to a high sensitivity region. An incident weak signal field with a few hundreds of kHz difference from the LO field is mixed with the LO field in the Rydberg system to generate an intermediate frequency signal, which is read out by Rydberg electromagnetically induced transparency (Rydberg-EIT) spectroscopy. Not like resonant EIT-Autler–Townes spectra, we realize the electric field measurement of the signal frequency from 2 to 5 GHz using a single Rydberg state. The detectable field strength is down to 2.25  μV/cm with sensitivity of the electrometry 712 nV cm−1 Hz−1/2, and a linear dynamic range is over 65 dB. The detectable field strength is comparable with a resonant microwave-dressed Rydberg heterodyne receiver using the same system, which is 0.96  μV/cm with sensitivity of 304 nV cm–1 Hz−1/2. We also show the system has an inherent polarization selectivity feature. Our method can provide high sensitivity of electric field measurement and be extended to arbitrary frequency measurements.

We demonstrate the measurement of super low-frequency electric field using Rydberg atoms in an atomic vapor cell with inside parallel electrodes, thus overcoming the low-frequency electric-field-screening effect at frequencies below a few kHz. Rydberg electromagnetically induced transparency (EIT) spectra involving 52D5/2 state is employed to measure the signal electric field. An auxiliary DC field is applied to improve the sensitivity. A DC Stark map is demonstrated, where the utilized 52D5/2 exhibits m j  = 1/2, 3/2, 5/2 Stark shifts and splittings. The m j  = 1/2 state is employed to detect the signal field because of its larger polarizability than that of m j  = 3/2, 5/2. Also, we show that the strength of the spectrum is dependent on the angle between the laser polarizations and the electric field. With optimization of the applied DC field to shift the m j  = 1/2 Rydberg energy level to a high sensitivity region and the laser polarizations to obtain the maximum m j  = 1/2 signal, we achieve the detection of the signal electric field with a frequency of 100 Hz down to 214.8 µV/cm with a sensitivity of 67.9 µV cm−1Hz−1/2, and the linear dynamic range is over 37 dB. Our work extends the measurement frequency of Rydberg sensors to super low frequency with high sensitivity, which has the advantages of high sensitivity and miniaturization for receiving super low frequency.

We investigate the response bandwidth of a superheterodyne Rydberg receiver at a room-temperature vapor cell, and present an architecture of atomic array to increase the response bandwidth. Two microwave fields, denoted as a local oscillator (LO) ELO and a signal field ESig, couple two Rydberg states transition of |52D5/2⟩ → |53P3/2⟩. In the presence of the LO field, the frequency difference between two fields can be read out as an intermediate frequency (IF) signal using Rydberg electromagnetically induced transparency (EIT) spectroscopy. The bandwidth of the Rydberg receiver is obtained by measuring the output power of IF signal versus the frequency difference between two fields. The bandwidth dependence on the Rabi frequency of excitation lasers is presented, which shows the bandwidth decrease with the Rabi frequency of probe laser, while it is quadratic dependence on the Rabi frequency of coupling laser. Meanwhile, we investigate the effect of probe laser waist on the bandwidth, showing that the bandwidth is inversely proportional to the laser waist. We achieve a maximum response bandwidth of the receiver about 6.8~MHz. Finally, we design an architecture of atomic array for increasing the response and keeping the sensitivity, simultaneously. Our work has the potential to extend the applications of Rydberg atoms in communications.