Intense ultrasound in a pressurized batch reactor was used for preparation of monolayered MoS2 nanosheets from natural mineral molybdenite. Exfoliation of bulk MoS2 using ultrasound is an attractive route to large-scale preparation of monolayered crystals. To evaluate the quality of delamination, methods like X-ray diffraction, Raman spectroscopy and microscopic techniques (TEM and AFM) were employed. From single- or few-layered products obtained from intense sonication, MoS2 quantum dots (MoSQDs) were prepared by a one-pot reaction by refluxing exfoliated nanosheets of MoS2 in ethylene glycol under atmospheric pressure. The synthesised MoSQDs were characterised by photoluminescence spectroscopy and laser-scattering particle size analysis. Our easy preparation leads to very strongly green luminescing quantum dots.

High-intensity ultrasound exfoliation of a bulk-layered material is an attractive route for large-scale preparation of monolayers. The monolayer slices could potentially be prepared with a high yield (up to 100%) in a few minutes. Exfoliation of natural minerals (such as tungstenite and molybdenite) or bulk synthetic materials (including hexagonal boron nitride (h-BN), hexagonal boron carbon nitride (h-BCN), and graphitic carbon nitride (g-C3N4)) in liquids leads to the breakdown of the 3D graphitic structure into a 2D structure; the efficiency of this process is highly dependent upon the physical effects of the ultrasound. Atomic force microscopy (AFM), transmission electron microscopy (TEM), and selected area electron diffraction (SAED) were employed to verify the quality of the exfoliation. Herein, this new method of exfoliation with ultrasound assistance for application to mono- and bilayered materials in hydrophobic and hydrophilic environments is presented.

Understanding materials with dimensions down to few nanometers is of major importance for fundamental science as well as prospective applications. Structural transformation and phononconfinement effects in the nanodiamonds (NDs) have been theoretically predicted below 3 nm size. Here we investigate the effect of size on the surface chemistry, microscopic structure, and Raman scattering of high-pressure high-temperature (HPHT) and detonation nanodiamonds (DNDs) down to 2-3 nm. The surface and size of NDs are controlled by annealing in air and ultracentrifugation resulting in three ND fractions. Particle size distribution (PSD) of the fractions is analyzed by combining dynamic light scattering (DLS), analytical ultracentrifugation (AUC), small angle X-ray scattering (SAXS), X-ray diffraction (XRD), and transmission electron microscopy (TEM) as complementary techniques. Based on the obtained PSD we identify size-dependent and synthesis-dependent differences of NDs properties. In particular, interpretation of Raman scattering on NDs is revisited. Comprehensive comparison of detonation 3 and pure monocrystalline HPHT NDs reveals effects of diamond core size and defects, chemical and temperature (in)stability as well as limitations of current phonon confinement models. In addition, low-frequency Raman scattering in the 20 -200 cm -1 range is experimentally observed.The size dependence of this signal for both HPHT NDs and DNDs suggests that it may correspond to confined acoustic vibrational, "breathing-like" modes of NDs.