Fused deposition modeling (FDM) is one of the most common additive manufacturing (AM) techniques for fabricating prototypes as well as functional parts. In this technique, several parameters may influence the part quality and consequently mechanical properties of fabricated components. In this paper, an experimental investigation on effects of fabrication temperature as one of the influential parameters on mechanical properties of manufactured parts is presented. A series of specimens fabricated at temperatures ranging from 180 to 260 • C were used for this investigation. X-ray computed tomography (CT) was used in order to non-destructively analyze the internal geometry of the specimens especially the bond between extruded filaments. Finally, the specimens were subjected to a uniaxial tensile load for evaluation of mechanical properties. The results showed that the specimens fabricated at lower temperatures have relatively lower tensile strength despite their considerably higher strain at break. In addition, the specimens fabricated at higher temperature range had significantly higher tensile strength because of the better bond between extruded filaments. The different mechanical responses were highly related to the internal geometry of the specimens and not necessarily the porosity. CT showed great potential as a non-destructive tool for investigation and development of FDM process.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.