No abstract

An experimental study of the influence of an exposed combustible ceiling on compartment fire dynamics has been performed. The fire dynamics in compartments with combustible cross-laminated timber ceilings vs non-combustible reinforced concrete ceilings in otherwise identical compartments with three different ventilation factors were investigated. The experimental results are compared against predictions from two theoretical models for compartment fire dynamics: (a) the parametric fire model given in EN 1991-1-2, and (b) a model developed at Technische Universität Braunschweig, which are the parametric fire models currently used in Germany. It is confirmed that the introduction of a combustible timber ceiling leads to higher temperatures within the enclosure, both under fuel-controlled and ventilationcontrolled scenarios. It is also demonstrated that the theoretical models considered in this article require refinement in order to adequately represent all relevant scenarios when combustible ceilings are present. A refinement of the German model, by adding the fuel from the combustible ceiling to the occupancy fuel load, was shown to not adequately capture the response for the ventilation-controlled fires.

No abstract

Purpose Incidents like the fire in the Channel Tunnel, where severe concrete spalling was determined, have led to requirements in limiting the spalling depth and involved zone to local and compatible magnitudes. Because the prevention of critical concrete spalling was also significant for the validity of the load-carrying capacity calculation for an existing railway tunnel, this paper aimed to investigate the spalling behavior of two contemplable concrete mixtures. The large-scale tests should show the load-carrying capacity over the whole duration of the fire exposure respecting all thermal and mechanical loads considered in the calculations. Design/methodology/approach In this paper, the fire behavior of two concrete mixtures for an existing railway tunnel are investigated. Small-scale tests prior to the main tests were conducted to identify an appropriate concrete mixture for the large-scale tests. During the large-scale tests, a tunnel segment is loaded with horizontal and vertical loads derived from a calculation taking into account the existing boundary conditions. Resulting restraint forces were calculated using the soil stiffness and tunnel fire design curve as fire scenario and applied via hydraulic jacks. To avoid additional restraint forces during the experiment, thermal strains due to fire exposure were allowed. Findings The results of the small-scale tests did not allow for a clear statement whether one concrete mixture would perform better regarding the spalling behavior. The two large-scale tests showed different results regarding the spalling behavior. Over the whole duration of fire exposure, the first test specimen remains nearly undamaged. During the test of the second specimen, spalling started about 3 min after burner activation. Because of the results, a suggestion for the concrete mixture of the first test was made, and this mixture was then used for the redevelopment of the existing railway tunnel. Originality/value The test setup was capable of incorporating all relevant boundary conditions for the analysis of an existing railway tunnel as part of an important north – south connection. The results have shown that a fire-proof construction is possible by adding polypropylene fibers to the concrete mixture. Additionally, it was possible to avoid the mounting of expensive and time-consuming fire protection measures like the installation of thermal insulation boards.

Summary In the context of recent fire damages to façades, and the related discussion about the safety of façade systems in the case of fire, there is a need to discuss the boundary conditions and the phenomena of façade fires based on fundamental investigation. This paper shows the experimental setup, procedure, and results of 5 large‐scale fire tests. The tests were carried out on a flat façade with external thermal insulation composite systems based on polystyrene concerning fire loads at the ground in front of the façade. The tests were scientifically monitored by the Institute of Building Materials, Concrete Construction and Fire Safety. The tests differ to the fire tests of the German building ministers in the case of different fire loads and the corner‐situation of the investigated façade. The 5 fire tests are the base for systematic investigations to study the examination criteria of the fire phenomena at the façades. Further experimental and numerical investigations will follow.