No abstract

Chitin/chitosan oligosaccharides composed of 2-acetamido-2-deoxy-D-glucopyranose (GlcNAc) and/or 2-amino-2-deoxy-D-glucopyranose (GlcN) were prepared by chemical degradation of chitin or chitosan and separated by gel permeation chromatography. Oligosaccharides obtained after enzymatic hydrolysis of chitosan [F(A) 0.19] with a fungal chitinase were derivatized by reductive amination with 2-aminoacridone and sequenced by matrix-assisted laser desorption ionization time-of-flight postsource decay (PSD) mass spectrometry (MS). The sequence of a trimer, D1A2, was established as D-A-A. The composition of a hexamer D3A3 was ca. 65% D-A-D-D-A-A and 35% D-D-A-D-A-A. The PSD MS of a nonamer D5A4-amac revealed four isobaric species D-X-Y-D-X-Y-D-A-A, where A is GlcNAc, D is GlcN, and X and Y (X not equal Y) are mutually either D or A. This structure motif was also observed in a dodecamer D7A5 which was composed of eight isobaric sequences of the general formula (D-X-Y)(3)-D-A-A.

No abstract

Clinical treatment of orthopaedic tissue injuries often involves the use of titanium and titanium alloys with considerable research focusing on the surface modification of these materials. Chitosan, the partly deacetylated form of chitin, is one of the materials under investigation as surface coating for orthopaedic implants in order to improve osteo-integration and cellular attachment. In this study, we determined the effects of the degree of deacetylation (DD) of chitosan membranes on attachment, proliferation and osteogenic differentiation of MC3T3-E1 mouse preosteoblasts. Chitosan membranes were coated with fibronectin to promote biocompatibility and cellular attachment. Membranes were characterized in terms of wettability and surface topography using water contact angle measurements and atomic force microscopy. The results in this study indicate that the surface roughness and fibronectin adsorption increase with increased DD. A higher DD also facilitates attachment and proliferation of cells, but no induction of spontaneous osteogenic differentiation was observed. Lower DD chitosan membranes were successfully prepared to sustain attachment and were modified by crosslinking with glutaraldehyde to promote long-term studies. The chitosan membranes used in this study are suitable as a potential coating for titanium implants.

A family 18 chitinase gene chiA from the thermophile Rhodothermus marinus was cloned and expressed in Escherichia coli. The gene consisted of an open reading frame of 1,131 nucleotides encoding a protein of 377 amino acids with a calculated molecular weight of 42,341 Da. The deduced ChiA was a non-modular enzyme with one unique glycoside hydrolase family 18 catalytic domain. The catalytic domain exhibited 43% amino acid identity with Bacillus circulans chitinase C. Due to poor expression of ChiA, a signal peptide-lacking mutant, chiADeltasp, was designed and used subsequently. The optimal temperature and pH for chitinase activity of both ChiA and ChiADeltasp were 70 degrees C and 4.5-5, respectively. The enzyme maintained 100% activity after 16 h incubation at 70 degrees C, with half-lives of 3 h at 90 degrees C and 45 min at 95 degrees C. Results of activity measurements with chromogenic substrates, thin-layer chromatography, and viscosity measurements demonstrated that the chitinase is an endoacting enzyme releasing chitobiose as a major end product, although it acted as an exochitobiohydrolase with chitin oligomers shorter than five residues. The enzyme was fully inhibited by 5 mM HgCl2, but excess ethylenediamine tetraacetic acid relieved completely the inhibition. The enzyme hydrolyzed 73% deacetylated chitosan, offering an attractive alternative for enzymatic production of chitooligosaccharides at high temperature and low pH. Our results show that the R. marinus chitinase is the most thermostable family 18 chitinase isolated from Bacteria so far.