We synthesized a series of acceptor-donor-acceptor-type small molecules (SIDPP-EE, SIDPP-EO, SIDPP-OE, and SIDPP-OO) consisting of a dithienosilole (SI) electron-donating moiety and two diketopyrrolopyrrole (DPP) electron-withdrawing moieties each bearing linear n-octyl (O) and/or branched 2-ethylhexyl (E) alkyl side chains. X-ray diffraction patterns revealed that SIDPP-EE and SIDPP-EO films were highly crystalline with pronounced edge-on orientation, whereas SIDPP-OE and SIDPP-OO films were less crystalline with a radial distribution of molecular orientations. Near-edge X-ray absorption fine structure spectroscopy disclosed an edge-on orientation with a molecular backbone tilt angle of ∼22° for both SIDPP-EE and SIDPP-EO. Our analysis of the molecular packing and orientation indicated that the shorter 2-ethylhexyl groups on the SI core promote tight π-π stacking of the molecular backbone, whereas n-octyl groups on the SI core hinder close π-π stacking to some degree. Conversely, the longer linear n-octyl groups on the DPP arms facilitate close intermolecular packing via octyl-octyl interdigitation. Quantum mechanics/molecular mechanics molecular dynamics simulations determined the optimal three-dimensional positions of the flexible alkyl side chains of the SI and DPP units, which elucidates the structural cause of the molecular packing and orientation explicitly. The alkyl-chain-dependent molecular stacking significantly affected the electrical properties of the molecular films. The edge-on oriented molecules showed high hole mobilities in organic field-effect transistors, while the radially oriented molecules exhibited high photovoltaic properties in organic photovoltaic cells. These results demonstrate that appropriate positioning of alkyl side chains can modulate crystallinity and molecular orientation in SIDPP films, which ultimately have a profound impact on carrier transport and photovoltaic performance.

No abstract

Bottom-contact bottom-gate organic field-effect transistors (OFETs) are fabricated using a low band gap pDTTDPP-DT polymer as a channel material and single-layer graphene (SLG) or Au source/drain electrodes. The SLG-based ambipolar OFETs significantly outperform the Au-based ambipolar OFETs, and thermal annealing effectively improves the carrier mobilities of the pDTTDPP-DT films. The difference is attributed to the following facts: (i) the thermally annealed pDTTDPP-DT chains on the SLG assume more crystalline features with an edge-on orientation as compared to the polymer chains on the Au, (ii) the morphological features of the thermally annealed pDTTDPP-DT films on the SLG electrodes are closer to the features of those on the gate dielectric layer, and (iii) the SLG electrode provides a flatter, more hydrophobic surface that is favorable for the polymer crystallization than the Au. In addition, the preferred carrier transport in each electrode-based OFET is associated with the HOMO/LUMO alignment relative to the Fermi level of the employed electrode. All of these experimental results consistently explain why the carrier mobilities of the SLG-based OFET are more than 10 times higher than those of the Au-based OTFT. This work demonstrates the strong dependence of ambipolar carrier transport on the source/drain electrode and annealing temperature.